seen from United States
seen from China
seen from United States
seen from Australia
seen from China
seen from Australia
seen from India
seen from Germany
seen from Malaysia
seen from Poland
seen from Netherlands
seen from Japan
seen from China
seen from United States
seen from Malaysia
seen from India
seen from India
seen from United States
seen from Maldives
seen from United States
أندرويد الخشبي سيكون متوفرا للبيع على الإنترنت قريبا
#أندرويد الخشبي سيكون متوفرا للبيع على الإنترنت قريبا
المجسمات الصغيرة بشكل أندرويد -إن صحت تسميتها- منتشره منذ فترة طويلة لكن الجديد الآن أنها أصبحت تتوفر مصنوعة من الخشب، الحقيقة أنها تبدو أجمل من السابق وأود الحصول على أحدها بواقع الأمر فأنا أحب أي شيء مصنوع من الخشب فغالبا يظهر بشكل أجمل. (more…)
View On WordPress
OMG it's Phillip. He accompanies me whenever I'm in a bit of a crunch, because he's a genius. A left-handed, stubby little Android genius.
He's also a fantastic jazz musician.
HOW TO MECHANIZED AN ANDROID FIGURE
This is what you need:
1 x Android Figure from DYZPLASTIC 1 x ATtiny44A from Mouser or Digikey 1 x 14 pin DIL socket 1 x Micro Servo SG90 (plastic) or MG90S (metal) 1 x Microphone e.g. CMC-5042PF-AC from Digikey 1 x Piezo (passive, not the buzzer kind) 2 x blue 5mm flat top wide angle LED from ebay 1 x red super bright 5mm LED 1 x green super bright 5mm LED 1 x yellow super bright 5mm LED 1 x NPN Transistor e.g. 2N3904 3 x 100nF ceramic capacitor 2 x 100K resistor 2 x 10K resistor 2 x 2K2 resistor (or other values depending on your blue LEDs) 3 x 150 resistor 1 x +5V power supply (e.g. USB charger)
And this is the instruction: http://www.instructables.com/id/Mechanized-Android-Figure/
