Easy home made diy harness!
So I thought I’d make a post about an easy harness you can make yourself that doesn’t cost much.
Things you will need:
1. An old pair of men’s underwear that has a large waist band. (I personally used a pair of American eagle boxers that had a hole in them. So rather than throw them away I made a harness! I really like the A&E ones because the waistband is so nice and thick but other brands are fine to use too as long as the waistband is intact.)
2. Scissors
That’s it you only need two things!
First take your scissors and cut the waistband away from the rest of the underwear you can do this neatly or not it doesn’t really matter you just need the waistband.
Next after cutting away the excess and your left with just the waistband put the waistband on and figure out where you want your packer to be placed on the band.
Last cut a small hole in the band where you want your packer to be. Don’t cut through the waistband just fold it and make a small cut in the middle of the fold. Pull the shaft of your packer through the hole (if you can’t make the hole bigger but start out with a small hole because you can always make it bigger but can’t make it smaller).
There you go! The packer should now be held in place by the band no o-ring or sewing needed!
(In the pictures posted it shows the finished band by itself in one picture and in the other it shows my packer gear packer pulled through the hole and how the harness can be used)
Note in the picture it shows my packer gear packer being used which is a small packer however I have also used my freetom sleek with this harness. So a range of packers/STP’s will work with this harness just make the hole the right size for the shaft to be pulled through it!
