How to Easily Make Good Cat6 Cable All The Time
Without question, buying Ethernet patch cables from a store is the most convenient and straightforward method of resolving networking issues. Where, however, is the joy in that? Why don't you construct your Cat6 Cable if you're utilizing Cat6 cables?
The procedure is straightforward. All you have to do now is read this post and follow the instructions carefully.
Gather All Equipment
RJ45 connectors, cat6 ethernet cables, cable boots, cable cutters, crimp tool, cable strippers, measuring tape, network tester, and a strong cup of coffee are all needed to build Cat6 cable.
Step 2: Length Measurements
To save cable, you must pay close attention to length considerations. When gauging lengths, remember to add around 4 inches on each end for plugs. For longer distances, the measurement factor becomes critical since it directly influences data transfer speeds. For example, cat6 cables support a data transfer rate of 10Gbps over 50 meters; however, this drops to 1Gbps over 100 meters. As a result, you must verify that your cable does not exceed the 100-meter restriction.
Strip the Cable
Measure 2 inches from the end of the wire. Then, in the cable strippers, place your Bulk Cat6 Cable 1000ft. Squeeze the cable snugly but not too tightly. Make sure your wire stripper's blade is perpendicular to the wire. Turn the stripper around the wire once to score the cable's sheathing. Remove the stripper and bend the ethernet cable parallel to the scoreline. Sheathing will be broken as a result of this activity. Remove and discard the broken covering from the Cat6 cable.
Preparing Inner Cables
The Cat6 Riser Pure Copper Cable conductors are no longer twisted together in four pairs once the sheathing is removed. The wires for the data plug are then organized in the next phase. T-568B and T-568A are the two most common variants these days. Moving left to right, we recommend the following configuration:
White Orange
Orange
White Green
Blue
White Blue
Green
White Brown
Brown
After you've configured the cables, you'll straighten them as neatly as possible. You don't need to bother about even lengths at this point; instead, focus entirely on straightening out the cables. When pruning cables via cable clutter, however, you must ensure that all wires are even.
Crimp The Connectors to The Cable
Insert your Cat6 cable into the RJ45 connector now. After you've inserted the wires into the connector, ensure the sheathing is inside the data plug's end; this will increase signal strength and protect them from interference. As you pinch the cable higher and move it closer to the connector, the sheathing will be pushed farther into the RJ45 connector. Next, place the plugin in the crimping tool and squeeze the handle. Then, on the opposite end, repeat the process.
Testing Phase
Now use testers to check your patch wire. You're good to go if the results are perfect.