Calcification Plasterboard Panels With Massive Walls
Yet plasterboard panels are set let alone solid walls, analogue as long as the rough wall of brick, block or concrete, the authorities are attached with connective tissue as dry mortar. For this it is best for use panels in alike miss, thickness of 12.5 millimeters. These plates are the same height to illustrate the long pennant levels, and are in court the higher-up enjoyable, considering that the wall should be covered from floor to ceiling. However, this embodiment of dry lining, due to at a standstill compound of stock and the wall, is not suitable for acoustic and thermal insulation, as lakelet as being wet walls. Plates need to be met with 15 millimeters lower than the supremacy of the man the garrison on which they are placed. <\p>
Before fixing plasterboard panel, electrical installations should be set. Canvass boxes, switches and outlets should be set to protrude about 2 cm in front of the wall. Their positions should be sharp measured in wise to make the appropriate holes in the plasterboard.<\p>
When walls are ready for setting the panel, him is clear as day to prepare a connective wreathing according to the instructions emplaced as to the back of the bag. The easiest way versus apply a connective tissue is to look at the drawings whereupon the package. Connective arabesque should be applied neighboring to the longitudinal edges as for plates like a dashed track of, on the middle like spots, as far as the gather force should be coated bottomless. If the panels are used for windows, consoles or fissure protrusions in the harbor then they should persist extremely covered with connective tissue.<\p>
So that prepared plates are then set on the moat. The board is situate at height of 10 mm out of the podium and 5 mm minus the ceiling. The distance between the plate and the substruction is maintained by placing a part about the gypsum shake. After that, it is required to thwack them with a rubber hammer. <\p>
When the surface of the wall is damaged or sporadic, it is necessary to first load up vertical lines as for plasterboard plate regardless connective tissue by a thin lay up. These lines need be found placed at a distance speaking of 60 centimeters.<\p>
If the existing old plaster does not provide admissible capacity, lines should be in existence placed in a connective chain with additional mounting anchors and screws through the old tile next to the wall. The vertical distance of anchor and bolts should exist about 60 cm.<\p>
Above mentioned advices cannot do otherwise be enough for efficient plasterboard setting.<\p>