Garbage Disposal Repair near Fort Myers, Naples, Cape Coral, Marco Island, Bonita, and Estero FL
Before attempting to install your garbage disposal, 📖 read and understand the entire InSinkErator safety and installation instructions included with your garbage disposal model. These are the materials needed when installing a new garbage disposal.
Plumber’s Putty (.1 kg)
Wire Nuts (2-size 54)
Worm Gear Clamp
Dishwasher Drain Connector Kit (optional)
Hammer
Channel-Lock Pliers
Flathead Screwdriver
Phillips Screwdriver
Pipe Wrench
The following instructions are for a first-time garbage disposal installation.
Disconnect the p-trap and the horizontal extension pipe.
Disconnect the down drain pipe.
Pry off the snap ring and clean off the old plumber’s putty.
Install the new sink flange.
Install gasket and flanges.
Slip-on the mounting and snap rings.
Remove the dishwasher knockout plug.
Connect the electrical*.
Hang the garbage disposal.
Insert the discharge tube.
Align the discharge tube with the drain pipe.
Lock the garbage disposal in place.
Test the garbage disposal.
*ELECTRICAL UNIT
Hardwired Unit: Turn the garbage disposal over and remove the electrical cover plate. Pull out wires. Insert cable connector (not included) and run electrical cable through the access hole on the bottom of the garbage disposal. Tighten the cable connector. Push wires into garbage disposal (do not displace cardboard shield) and replace the electrical cover plate.
Corded Unit: For garbage disposal with a factory-installed cord, simply plugin to the outlet under your sink after completing the rest of the steps.
Having trouble installing your garbage disposal? You may need a help from professional 👨🔧. Contact Appliance Doctor at:
📲📲 Cape Coral: 239-540-9500
📲📲 Estero/Bonita Springs: 239-992-0505
📲📲 Fort Myers: 239-936-0111
📲📲 Marco Island: 239-642-0505
📲📲 Naples: 239-434-7546
📲📲 East Naples: 239-732-0111