FINALLY getting back to the maple and walnut chevron inlay. The 12" glue up was too daunting so I put it off for a bit to think on it. There's no sure way to get it right without a vacuum bag setup, so I altered course and cut 2" segments. Since this is essentially a veneer inlay, I think 2" will provide plenty of surface coverage, and it's way easier to control a consistent glue up without gaps everywhere (a byproduct of gluing thin material is the curl-back that always occurs on a non clamped area) Fingers crossed, maybe I can set this in the project this weekend! . . . . . #wood #woodwork #woodworker #woodworking #inlay #chevron #chevrons #maple #walnut #wallart #wallcaddy #etsy #etsyshop #etsyseller #diy #doityourself #finewoodworking #thejawnshop