EEEGUIDE.COM @eeeguide - Tumblr Blog

The circuit diagram of the Foster Seeley detector is shown in Fig. 22.54. This Foster Seeley Detector circuit consists of an inductively

This Foster Seeley Detector circuit consists of an inductively coupled double tuned circuit in which both primary and secondary coils are tuned to the same frequency (intermediate frequency).

The circuit using an SCR as half wave rectifier is shown in Fig. 26.30 (a). The ac supply to be rectified is applied to the primary of the

SCRs are very useful in ac circuits where they may serve as rectifiers whose output current can be controlled by controlling the gate current. An example of this type of application is the use of SCRs to operate and control dc motors or dc load from an ac supply.

For Two SCR as Full Wave Rectifier are connected across the centre taped secondary, as shown in Fig. 26.32 (a). The gates of both SCRs are

SCR as Full Wave Rectifier: For Two SCR as Full Wave Rectifier are connected across the centre taped secondary, as shown in Fig. 26.32 (a). The gates of both SCRs are supplied from two gate control supply circuits.

Read More on this SCR as Full Wave Rectifier below…

DIAC Definition, Basic Structure and Schematic Symbols, Construction, Working Principle, VI Characteristics and Application of DIAC.

The four layer diode, also called the Shockley diode after its inventor Willian Shockley, is essentially a low-current SCR without a gate.

Gate controlled switch is designed for easy opening with a reverse-biased trigger. A gate controlled switch (GCS) is closed by a positive

Silicon controlled switch (SCS), like the SCR, is a unilateral, four layer, three junction P-N-P-N silicon device with four electrodes namely

Light activated SCR is just an ordinary SCR except that it can also be light triggered. Most LASCRs also have a gate terminal for being

The structure of a vertical NPN power transistor is shown in Fig. 26.74. In the vertical configuration for power BJT, the collector terminal

UJT Triggering of SCR Working Principle - One common application of the unijunction transistor is the triggering of the other devices such

UJT Relaxation Oscillator - The relaxation oscillator shown in Fig. 26.94 (a) consists of UJT and a capacitor C which is charged through

UJT as Over Voltage Detector Circuit Diagram - A simple dc overvoltage detector circuit is given in Fig. 26.96. It operates on the fact that

UJT as Over Voltage Detector Circuit Diagram

In case of Single Phase Full Wave Controlled Rectifier (or Converter) both positive and negative halves of ac supply are used and, therefore,

If two of full converters are connected back to back, it is known as Single Phase Dual Converter. In that both the output voltage and the load

Three phase converter could be half-wave, semiconverter, full-converter and dual converters. The 3-phase half-wave converter drives are only

The circuit diagram of a Step up Chopper is shown in Fig. 27.28 (a). In figure, the chopper is represented by a switch S. In this chopper, a

Step up Chopper

This is also known as a buck-boost converter. The principle of operation of Step up Step down Chopper is illustrated in Fig. 27.29. As shown,

Trending Blogs

Recently Viewed Blogs

EEEGUIDE.COM