How To Fix Barbecue Grill Regulator Issues
The next-door neighbors are getting impatient; the children are getting uneasy; and your wife keeps giving you the look like "I should have simply prepared every little thing in the cooking area!" Have you experienced all these due to barbecue delay? Now what? It's most likely not about your food but your barbecue grill.
Below are typical issues and some ideas to assist you repair low flame output on your barbecue grill.
Regulator issues
Your regulator, the assembly on the hose before it screws into the propane tank, may have been stuck and needs to be reset. How? Follow these steps (or examine with your manufacturer):
1. Switch off the gas at the propane tank.
2. Disconnect the hose from the propane tank.
3. Open the cover of your BBQ Grill.
4. Turn all the burners to high temperature.
5. Wait for 2 mins (just time sufficient for a soda).
6. Turn off all the burners.
7. Connect the gas line back up to the propane tank.
8. Turn the gas on slowly on the propane tank.
9. Light the grill using your regular lighting procedures. If the regulator was stuck, it needs to have been reset benefiting from these steps. If you constantly turn off your burner valves initially prior to switching off the gas at the tank, you will keep the regulator from sticking once again. Provide it a 2nd shot if you still have reduced flame or yellow flame. You better replace it if there is no result.
One blogger had a reader submit the following through email. He was having problems with his Uniflame 5-burner Grill. When lighting the burners until he lit the 5th burner, every little thing worked fine. When the 5th burner was switched on, the other 4 either go out or the flame turns truly low and then goes out. He spoke with Uniflame Client Care Center and they reported that occasionally the regulator hose gets a gas blockage. They recommended him to fix it with the following steps:
1. Turn the tank off.
2. Disconnect the hose.
3. Open the grill and side burner valve and any other systems.
4. Open the controls completely and leave for 45 sec to 1 minute.
5. Re-connect the hose, turn on the tank and attempt a re-light on the grill. It could be the regulator hose if it still does not work.
The man`s fired right up without any issues.
One other tip: Constantly open your propane tank valve gradually to keep the pressure in the tank from frustrating your OPD valve or the regulator. Wait a couple of minutes after turning the gas on prior to lighting the grill. This will allow time for the pressure to level prior to lighting the grill. If you're having issues with reduced flame or yellow flame output, you might need to do some repair works on your grill. We have actually discovered Appliance Manufacturing facility Parts to be a trustworthy selection for grill parts (regulators, venturis, hoses, grill burner assemblies, and so on).
For more great barbecue fixing tips, make sure to check out this really cool Facebook Fan Page and Barbecue tips and tricks Google Plus Page.