#bltouch

[marshwildman]

Got the automatic leveling unit and the magnetic flexible build plate installed! #bltouch #ender3v2 #creality #3dprinting (at Colonial Heights) https://www.instagram.com/p/CVWAF_xh3CA/?utm_medium=tumblr

[themaker]

[thecrazymakernerd]

After two days of testing various Firmwares, wiring, and tutorials I found this method to work for the #CR10s5 with the #blTouch !!! Please use it to save you a lot of headachees, swearing, and constant advice to buy another brand of sensor. 🤓 #CrazyMakerNerd #3dprinting #3dprinter #cr10 #cr10s #cr10s4 #bedlevel https://www.instagram.com/p/CAJbE6Wn-0v/?igshid=as3uapxjvce7

[thetinyarchitect]

Still no response from Antclabs, but I'm sure I have a bad probe. See how far the probe has to go up before registering? Turns out there are additional issues with the V.3. this has turned out to be a massive pain in the ass. #antclabs #ender3 #bltouch #bltouchv3 https://www.instagram.com/p/BwNfg9DnUEi/?utm_source=ig_tumblr_share&igshid=l3xbiggckenv

[thetinyarchitect]

I upgraded the firmware with my Uno, I ran marlin and verified the settings. Why is it failing the probe and digging the nozzle into the bed? #ender3 #bltouch #3dprinter https://www.instagram.com/p/BwKabSdH7zW/?utm_source=ig_tumblr_share&igshid=16bnn76tfs2l5

[thetinyarchitect]

I need help. The BLTouch is not working properly and I can't get a good fix anywhere. Don't need any trolls commenting on the state of the print bed or anything else about the setup. DM if you know how to diagnose and repair. #3dprinter #ender3 #bltouch https://www.instagram.com/p/BwKZ2qLnW53/?utm_source=ig_tumblr_share&igshid=ot6f6295i9rc

[make-o-rama]

Schnell mal ne Halterung für nen BLTouch am Ender 4 gestaltet und gedruckt (Igus iglidur l150). #igus #justprinteverything #makeorama #3ddruck #3dprinting #bltouch (hier: Make-o-Rama)

[fablablueneburg]

    https://www.antclabs.com/bltouch

https://www.antclabs.com/wiring1

    Marlin 1.1.8 BLTouch