seen from United Kingdom
seen from Malaysia
seen from Bulgaria
seen from China
seen from Pakistan
seen from United Kingdom
seen from United States
seen from Taiwan
seen from Philippines
seen from China
seen from United States
seen from China
seen from Russia
seen from United States
seen from Malaysia
seen from Brazil
seen from Malaysia
seen from United Kingdom
seen from France
seen from Australia
May sound a bit dumb, but this is the part I struggled with the most. This is the plug on the back of the touchscreen.
There are no photos on the manufacturers website to show you side this plug goes in. There is some green tape on the bottom of the plug, make sure it is facing down, and slide the plug into place. It will clip in once fitted in the correct spot.
As promised, here are some pictures of the 10" Touchscreen and LVDS converter purchased from Chalkboard Electronics.
Its worthwhile mentioning that these pictures are lacking the power adapter, which I purchased seperatly. This device requires a 5V/3A power adapter with a 2.5mm DC by OD 5.5mm plug. I purchased a Powertech PLUS Switchmode Regulated Plugpack (MP-3480) from Jaycar that comes with 7 different plugs that can be switched over at any time for any future projects.
Also interesting to note that the cable does not come with a mini USB board as per the instructions provided by Chalbve Board Electronics here. I was a bit worried but soon realised that they have since added an attached the USB plug and concealed the board on newer models.
I will be providing assembly instructions and photos for the Touchscreen in the near future.
Picture from manufacturers website. Will upload photos after I get home from work today.
Dimensions of the display (in millimeters) are 264 x 180 x 6.5
