Introduction:
The contact part between the mixer and the material (mixing chamber/side plate/hammer/impeller shaft) use imported alloy material to ensure that the mixing chamber is firm and wear-resistant. It is suitable for dispersing and mixing other formulations such as metal, ceramic powder and binder. After the materials are in the form of mud, they are discharged before the next process. (It is the best mixing equipment for small batch production, sampling, laboratory and teaching).
Â
 Working Principle:
There are two rotors in the mixing chamber, which rotate relatively at a certain speed ratio. The material from the feeding port is clamped and brought into the roll gap to be extruded and sheared by the rotor. After passing through the roll gap, the "W" sharp edge of the mixing chamber is divided into two parts, and then returns to the upper part of the rotor along the gap between the front and rear chamber walls and the rotor. In the closed chamber, under certain pressure and temperature, the material is sheared and mixed to make the formula material fully dispersed and plasticized, so that the formula can give full play to its best effect.
Â
Mixing System
The mixing chamber has a "W" shape and adopts an "M" shaped hammer to form a fully closed mixing space. Stirring blades are designed with prismatic spiral without dead corners, which makes the material shear and disperse to meet the requirements of physical properties. The stirring blade is of hollow structure. The connect part with the materials (mixing chamber/side plate/hammer/stirring blade ) is made of imported alloy. After quenching and tempering, high-precision machining and vacuum heat treatment, which is wear-resistant, corrosion-resistant, not easy to stick to the material and with long service life.
Â
Advantage of Open-close type Kneader:
1 The material is used imported alloy
2 Open totally with no dead angle.
The mixing chamber is automatically opened by hydraulic system, and the rotor is convenient to disassemble. The defects of difficult cleaning, color change and maintenance of the traditional mixer are broken. All contact surfaces with material mixing in the mixing chamber are subjected to mirror polishing treatment, and the high-gloss mirror surface enables the material not to stick to the wall and is easy to clean, thus effectively solving the problem of material pollution.
Our Machine Technical advantage:
（1）.Mechanical shaft seal tightening technology, self-lubricating sealing ring，to ensure the sealing ring always in the pressure seal state in the mixing process. Self-lubricating sealing ring can reduce the wear of the densification system, and can effectively reduce the noise caused by powder leakage and poor sealing. It can greatly improve the function of anti-leakage powder to make cleaning, changing color and disassembly more simple and convenient. It can reduce the pollution of materials/
（2）.Our machine use penetrating heating system to improve heating efficiency at 50% higher than the traditional heating plate
（3）.The mixing chamber adopts complicated tube and belt type design, with good heat exchange and accurate temperature control. The rotor adopts water cooling, which effectively prevent sticky materials,accurate temperature control and make the materials more evenly dispersed.
Read the full article
prguitarman
discoholicmusic
ellievsbear
amandla