This was one of the most challenging panels that I have made. It was also my first time using a power hammer to stretch the flange. Take a look at the process 👉🏼👉🏼👉🏼 to make that part. Started with a good templet. A little low crown wheeling then to the power hammer to stretch out the flange then used the planishing hammer to stretch the bead part. Then I used my thumbnail dies on the pullmax and shrunk it back down to the top of the bead. After that @castnoanchor and I ran it on the pullmax though the final bead dies that we made. #EmpireFabrication #empirefab #hamb #choptop #pullmax #choprepair #ialwaysfixotherpeoplesmistakes (at Empire Fabrication) https://www.instagram.com/p/BvuXd6cBH5T/?utm_source=ig_tumblr_share&igshid=1odls0acjjs3x















