. Bits&Bobs .

ALi HUMPHREY - I'm a fine art student and this blog will show all the little bits and bobs I do through my study's and anything else I get up to.

[studentartthings]

Final Piece - Bubble Structures Installation

900 single bubbles, over 5000 staples to connect & 4.2miles of cling film

(FMP Organic Structures) By Alice Humphrey

[studentartthings]

PROPOSAL for hanging piece in the middle of the stairs based on bubble structures

(FMP Organic Structure)

[studentartthings]

Drawing (FMP Organic Structures)

Drawing with pen, charcoal, line drawing, tube printing, Lino cutting prints.

[studentartthings]

Bubble Printing - bubble structures & connected lines.

(FMP Organic Structures)  By Alice Humphrey

[studentartthings]

My FMP Finial Piece - Organic Structures, Installation Based on Bubble Forms. My installation is made from approximately seven thousand metres of cling film or four point two Miles forming some nine hundred individual bubbles all connected by five thousand staples.

[studentartthings]

Just under half of my bubble structure installation is up and hanging  !! Working progress...  

[studentartthings]

Hanging Bubble Sculpture / Installation -  made from clean-film, stapled together and hanged with fishing wire!

[studentartthings]

-WORKING PROGURESS-

Starting of a bubble structure wall installations piece- I will start dense in the corner and fade it out.

[studentartthings]

Both study drawings together! - charcoal.

[studentartthings]

Projecting my clean film bubble structures - photographs.

[studentartthings]

Study Drawing of my bubble structures - charcoal (inverted)

[studentartthings]

Study Drawing of my bubble structure - charcoal.

[studentartthings]

Bubble Structure Sculpture Tester- made out of clean film and simple stapled together!

[studentartthings]

Organic Structures - working with bubbles! bubble prints, photos, drawing & 3d work (clean film).

[studentartthings]

Progress with creating wire ribs inside a clean-film body and playing around with a bit of lighting...

[studentartthings]

Playing around with projector and my little test run wire human ribs (unfinished) & covering with clean film. Starting to like how it looks, Little like an x-ray!  

[studentartthings]

Layered Pigs Heart Print - where I prints out side and in side of the heart onto acetate and then layer them to create a more fuller image. Following photograph of the pigs heart I used to print from.