#autowreckers

[chilaquilesheel]

RIP Automedon you would have loved Formula One 🏎️💨

[sngl-led-auto-lights]

I have a 2007 Chevy Avalanche and the headlights and taillights come on and it tries to turn over and it doesn’t, it’s weak. Can it be the battery?

Yes, a weak or failing battery is the most likely cause of your symptoms in a 2007 Chevy Avalanche. Here's a breakdown of why, along with troubleshooting steps:

Why the Battery is Suspect Symptom Match:

"Lights come on but won't crank/cranks weak": Headlights/taillights require minimal power (5–15 amps), while the starter needs 400–600+ amps. A weak battery might power lights but fail under high-load demands.

"Tries to turn over but weak": Indicates low voltage reaching the starter. Avalanche-Specific Factors:

Leaky Batteries: Older batteries (3+ years) lose cranking power.

Corroded Terminals: Common on GM trucks; causes voltage drop.

Parasitic Drain: Faulty modules or aftermarket accessories slowly drain the battery.

Troubleshooting Steps Check Battery Voltage:

Use a multimeter on battery terminals (key off).

Healthy: 12.4V–12.7V.

Weak: Below 12.2V → Needs charging/replacement.

Critical Failure: Below 11.8V → Will not crank. Test Under Load:

Have an assistant crank while monitoring voltage.

Voltage Drops Below 9.6V: Battery can't hold charge → Replace.

Voltage Drops Below 10.5V: Weak/starter struggling → Jump-start test. Clean Battery Terminals:

Remove cables → Scrape corrosion off terminals/posts with a wire brush → Reattach tightly. Try Jump-Starting:

If jumps successfully starts the truck → Bad battery or charging issue.

Fails even when jumped? → Bad starter, ground, or wiring.

Other Possible Causes (If Battery Tests Fine) Component Symptoms Overlapping w/Battery How to Check

Starter Motor Slow/weak cranking, clicks/no crank Tap starter lightly with a hammer while cranking; if starts → Replace. Ground Connections Voltage drops under load Inspect chassis ground near battery/starter → Clean corrosion. Alternator Battery not recharging while driving Test charging voltage at idle → Should be 13.5–14.8V. Starter Solenoid/Relay No crank/single click Swap starter relay with identical one (e.g., horn relay).

Quick Avalanche Checks Fuse Box: Inspect underhood fuse/relay center (common failure).

Ignition Switch: Faulty switch can cut power to starter circuit.

Fuel Pump: Listen for hum at key-on (no hum = fuel problem).

Recommendation

Start with the battery → 90% of "weak crank with lights on" cases are due to battery issues. If the battery is 3–5+ years old, replace it (use a group 75 battery with ≥700 CCA).

If newer, charge it fully and have it load-tested at any auto parts store (free service).

If a new battery doesn't fix it, suspect a starter or corroded ground cable at the engine block. For wiring checks, see an Avalanche-specific wiring diagram (https://gmt800parts.com/wiring-guides). Safety Tip: Always disconnect the negative cable first and reconnect last to avoid shorts!

[sunshinewreckers]

https://sunshinewreckers.com/quality-auto-parts-from-sunshine-wreckers-your-premier-mercedes-benz-wreckers/

[occhichemiuccidono]

[randalautoblog]

Imagine: the excitement of the hunt, the excitement of a bet, and the opportunity to leave with a good deal. Buying a car at a car auction takes some preparation and research, but the reward is well worth the chance to drive the car at a super-affordable price. On some online auctions, such as A Better Bid, you can get a good model like ford bronco 1964 at a very affordable price.

Buying a car at auction? In person or online, what will you choose - state or public auction? But wait, before you hit the auction or log into your laptop, let's talk about best practices. First, where do these cars come from? And more importantly, how do you ensure that you are making a smart investment? There are some very cool events going on at car auctions where you can bid on cars and get great deals. Some auctions are exclusive to car dealers, but others are open to the public and you can find them all over the country. In fact, there are tons of them in many states. And the best part: you don't even have to leave your home to participate! It's like buying a house without even setting foot in it. So why not give it a try and see what rides you can get!

Are you looking to spice up your online shopping experience? Why not try attending an online auction! Of course, this option may not be for the indecisive or picky shopper, but it's definitely worth a shot. Some auctions even allow you to bring a mechanic to check out the vehicle beforehand, but beware of those that keep the VIN a secret - that's usually a red flag. Add some excitement to your online shopping and give an auction a try! Have you ever wondered how cars end up at auction? It's not always because of a terrible accident or a car's last breath. In fact, some cars are there because rental companies or financial services firms just didn't want them anymore. And, during the pandemic, rental companies were selling off their vehicle fleets in droves. Another reason cars end up at auction is because they were seized or repossessed by banks, the IRS, or other government agencies. 

Stepping up to the auction car buying game? You might be wondering how to get into those closed-off auctions. Well, without a dealer license, it's a no-go. But don't get discouraged - there are plenty of public options for you to explore. If you're going for an in-person auction, make sure to do your homework first. Each auction has its own unique rules and caters to different markets. 

[isottafraschini]

Abarth 1500 Coupe Biposto '1952 Bertone

Abarth 1500 Coupe Biposto

Abarth 1500 Coupe Biposto

Abarth is an Italian company founded by Carlo Abarth in 1949 in Turin. Main activities: production of mufflers and exhaust pipes, racing cars, and since 1955 - modification of production Fiat cars. The company has partnered not only with Fiat, but also with brands such as Alfa Romeo and SIMCA, developing racing versions of standard models. But Abarth gained worldwide fame thanks to his tuning kits for the Fiat 500 and 600, which turned cheap small cars into racing cars.

Design Abarth 1500 Coupe Biposto

Abarth 1500 Coupe Biposto

In order to attract the public's attention to his products, Abart needed a concept car with a unique style. In 1952, he turned to Franco Scaglione, an up-and-coming designer from the Bertone atelier. The car, known as the Abarth 1500 Biposto, was built on a Fiat 1400 chassis.

Design Abarth 1500 Coupe Biposto

Abarth 1500 Coupe Biposto

It had an overhead valve engine increased to 1480cc, two Weber carburetors, a 4-speed gearbox and independent front and rear suspension.

Design Abarth 1500 Coupe Biposto

Abarth 1500 Coupe Biposto

The Skaglione-designed two-seater featured a unique front end architecture with a third headlight in the center pushed far forward, a dynamic wheel arch pattern, a huge curved rear window and tail fins. After working on Abarth, Skaglione became famous for the B.A.T. project, the main ideas of which were already embodied in 1500 Biposto.

Abarth 1500 Coupe Biposto

Standing out from the new models on show at the 34th Turin Motor Show in 1952 was the characterful Bertone coupé built on Fiat 1400 mechanics reworked by Abarth. The style of the Turin bodywork builder shines through, even in this almost excessively original version of the Abarth Coupé.

Interior Abarth 1500 Coupe Biposto

Abarth 1500 Coupe Biposto

The prototype stands out for its impressive front view, with the third central headlight reaching forward, and for the dynamics of the wheel arches which underline the car’s sporty character. The large wrap-around rear windscreen and the interesting profile of the tail fins, which were taken all the way with the B.A.T. experiments (1953-1955) testify to the work which went into the lines of the car, and the focus on innovative elements which work perfectly together.

Design Abarth 1500 Coupe Biposto

The Abarth 1500 continues to delight with its futuristic design. At the 2010 Pebble Beach Concours d'Elegance, he won the prestigious Gran Turismo trophy.

I will introduce you to the Cars of the World of different years of release.

Introduce you to the Beauty of the Automotive world.

Abarth 1500 Biposto Coupe (Bertone), 1952

Support my channel and subscribe

Vintage Motors Car The Sound Engines

https:www.youtube.com/channel/UC6jpDjNAf_VcTteAYn6MYlg

Who will reblogged, I will block, I warned.

[brisbanecarwreckers-blog]

How To Earn Money By Old Cars?

We offer cash for old cars Brisbane against old, scrap, junk, used, damaged cars of any type/model in any conditions, with FREE car removal in Brisbane.

[sngl-led-auto-lights]

Can a halogen headlight be converted to LED?

Technically, yes, but there are some key issues with legality, safety, and performance. Here’s what you need to know:

🔧 How the conversion works Plug and Play (PnP) LED bulbs

Fit into halogen sockets (H1, H4, H7, 9005, etc.).

Built-in driver to convert 12V DC to LED voltage.

Example: “Halogen to LED” bulb kit.

⚠️ Key Disadvantages and Risks Issue Importance

🗲 Illegal in most areas Non-compliant LED bulbs in halogen housings scatter light excessively → glare other drivers. This violates DOT/FMVSS 108 (US) and ECE (Europe) standards. ☢ Poor beam pattern Halogen housings have reflectors designed to the shape/size of the halogen filament. No adjustable light pattern LEDs emit light differently → produce dark spots/scattering (“moth effect”). 🚨 Safety Hazard: Due to the uneven beam, your visibility is reduced and the risk of dazzling oncoming vehicles → accidents is increased. 🔌 CanBus Error: Modern cars detect low LED power draw as "bulb burnt out" and trigger a dashboard warning. Resistor may be required. 📛 Inspection Failure: Most states/provinces will fail your vehicle inspection for non-compliant lamps.

🔬 Technical Challenges Heat Dissipation: LEDs require heat sinks, which are too long/fans too large (may not fit in a sealed housing).

Bulb Orientation: LEDs require precise rotational alignment (many bulbs do not adjust well).

Vibration Damage: Improperly secured LEDs may fail prematurely.

✅ Safer, legal alternatives Solution Pros Cons

🔦 High-performance halogen lamps (Philips X-tremeVision, OSRAM Night Breaker) Legal, plug-and-play, 20-30% brighter, shorter life (400-600 hours) 💡 OEM LED/Projector lamp conversion Replaces complete headlight assembly → Legal, beam pattern optimized Expensive ($500-$2000+ per pair) ⚙️ Professional projector lamp conversion Custom HID/LED projector lamps installed into housing Expensive ($130-$800+), requires expertise

⚖️ Decision checklist

Before conversion: Check local laws (must be DOT/ECE compliant).

Ask your insurance company if conversion will affect insurance.

Test beam pattern: Install LED lamps in a dark garage - do not drive if beam cutoff is blurry or uneven.

Consider warranty - aftermarket LEDs may void your headlight warranty.

💎 KEY ADVICE

Avoid plug-and-play LED bulbs in halogen housings. Recommended choices: High-output halogens for economical performance.

Full factory LED assemblies for superior performance.

If pursuing a custom upgrade, have it professionally retrofitted.

🌟 Bottom line: While physically possible, inferior LED bulbs in halogen housings compromise safety and legality. Prioritize compliant solutions to avoid fines, incidents, or inspection failures. If you proceed, use only reputable brands (e.g. Philips, SNGL) with a proper fan/heatsink design and turn your headlights down to reduce glare.