#beam press

[taiweimachinery]

Taiwei microcomputer precision four-column hydraulic cutting machine is suitable for cutting and molding leather, plastic, textile, asbestos, rubber, cardboard, cork and other materials. It is widely used in cutting and forming operations of non-metallic materials such as shoes, handbags, toys, silk flowers, sponges, plastics, automobiles and other industries and packaging materials.

[jccullen]

SCHWABE Die Cutting Beam Press using Die Vac System used on 6 out of 10 vehicles Wards Auto Best Interiors 2020

SCHWABE Die Cutting Beam Press using Die Vac System used on 6 out of 10 vehicles Wards Auto Best Interiors 2020

Below are the Wards Auto 2020 Best Interiors vehicles using SCHWABE USA Straight Ram Hydraulic Beam Press with a Progressive Feed System using the DIEVAC® System by ODI.

Mercedes-Benz GLB (leather seats)

Hyundai Venue (leather seats)

Nissan Sentra (cloth seats)

Toyota Highlander (cloth seats)

Lincoln Aviator

Chevrolet Corvette

View On WordPress

[jccullen]

  Dual Power Tables – Heavy Duty steel tables.

Tables will be designed so that customer cutting tool can be placed on the table to be placed under the cutting head for bolting the tool to the cutting head.

Table capable of holding up to 2,500lb tool

Feed System

Tables to be powered via an air cylinder (standard – not rodless). Operator station with cycle start activation buttons will be mounted at the end of each table for operator convenience

Dual tables

Light curtains included on each side of machine for safe operation Corner brackets (quantity to be determined at time of engineering) will be included so that operator can properly position the Sheet Material to ensure it aligns with the cutting die when the table enters the cutting area Cutting Press.

Cutting Surface 

– Nylon cutting pad on each table. – Oscillating Pad Shifter – Designed to incrementally move the cutting pad after each stroke to prevent the cutting die from cutting into the same location on the pad after each stroke. One pad shifter to be installed on each table (2 shifters TOTAL) -Will drastically increase the life of the cutting surface -Material alignment brackets will be mounted so that they are not affected by the pad oscillating to ensure that the material aligns with the die before being cut

Stroke Control – Controlled by Linear Transducer which allows the die height to be adjusted infinitely in increments of 0.001”

NEW Hydraulic Beam Press 150 tons with Dual Power Feed Tables Dual Power Tables – Heavy Duty steel tables. Tables will be designed so that customer cutting tool can be placed on the table to be placed under the cutting head for bolting the tool to the cutting head.