Discover Top Posts Tagged with #cellular structures

Design and Development of Honeycomb Structure for Additive Manufacturing

by Narendra Kumar Rajak | Prof. Amit Kaimkuriya "Design and Development of Honeycomb Structure for Additive Manufacturing"

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-2 | Issue-6 , October 2018,

URL: http://www.ijtsrd.com/papers/ijtsrd18856.pdf

Direct Link: http://www.ijtsrd.com/engineering/mechanical-engineering/18856/design-and-development-of-honeycomb-structure-for-additive-manufacturing/narendra-kumar-rajak

ugc approved engineering journal,ugc approved journals for engineering, open access journal of engineering

the demand for shorter product development time has resulted in the introduction of a new paradigm called Additive Manufacturing AM . Due to its significant advantages in terms of cost effective, lesser build time, elimination of expensive tooling, design flexibility AM is finding applications in many diverse fields of the industry today. One of the recent applications of this technology is for fabrication of cellular structures. Cellular structures are designed to have material where it is needed for specific applications. Compared to solid materials, these structures can provide high strength-to-weight ratio, good energy absorption characteristics and good thermal and acoustic insulation properties to aerospace, medical and engineering products. However, due to inclusion of too many design variables, the design process of these structures is a challenge task. Furthermore, polymer additive manufacturing techniques, such as fused deposition modeling FDM process which shows the great capability to fabricate these structures, are still facing certain process limitations in terms of support structure requirement for certain category of cellular structures. Therefore, in this research, a computer-aided design CAD based method is proposed to design and develop hexagonal honeycomb structure self-supporting periodic cellular structure for FDM process. This novel methodology is found to have potential to create honeycomb cellular structures with different volume fractions successfully without any part distortion. Once designing process is complete, mechanical and microstructure properties of these structures are characterized to investigate effect of volume fraction on compressive strength of the part. Volume fraction can be defined as the volume percentage of the solid material inside the cellular structure and it is varied in this thesis by changing the cell size and wall thickness of honeycombs. Compression strength of the honeycomb structure is observed to increase with the increase in the volume fraction and this behavior is compared with an existing Wierzbicki expression, developed for predicting compression properties. Some differences are noticed in between experimentally tested and Wierzbicki model estimated compressive strength. These differences may be attributed to layer by layer deposition strategy and the residual stress inherent to the FDM-manufacturing process.

#Mechanical Engineering #Computer-aided design #Cellular structures