#compute mean

[engineeringmath]

Introduction to Statistics and Data Analysis | Probability & Statistics for Engineers & Scientists | Walpole | Problem 1.7

Consider the drying time data for Exercise 1.1 on page 13. Compute the sample variance and sample standard deviation.

Solution:

We know, based on our answer in Exercise 1.1, that the sample mean is .

To compute for the sample variance, we shall use the formula

The formula states that we need to get the sum of , so we can use a table to solve for every sample.

The table above shows…

View On WordPress

[engineeringmath]

Introduction to Statistics and Data Analysis | Probability & Statistics for Engineers & Scientists | Walpole | Problem 1.6

The tensile strength of silicone rubber is thought to be a function of curing temperature. A study was carried out in which samples of 12 specimens of the rubber were prepared using curing temperatures of 20° C and 45° C. The data below show the tensile strength values in megapascals.

20° C: 2.07 2.14 2.22 2.03 2.21 2.03 2.05 2.18 2.09 2.14 2.11 2.02 45°…

View On WordPress

[engineeringmath]

Introduction to Statistics and Data Analysis | Probability & Statistics for Engineers & Scientists | Walpole | Problem 1.5

Twenty adult males between the ages of 30 and 40 were involved in a study to evaluate the effect of a specific health regimen involving diet and exercise on the blood cholesterol. Ten were randomly selected to be a control group and ten others were...

Twenty adult males between the ages of 30 and 40 were involved in a study to evaluate the effect of a specific health regimen involving diet and exercise on the blood cholesterol. Ten were randomly selected to be a control group and ten others were assigned to take part in the regimen as the treatment group for a period of 6 months. The following data show the reduction in cholesterol experienced…

View On WordPress

[engineeringmath]

Introduction to Statistics and Data Analysis | Probability & Statistics for Engineers & Scientists | Walpole | Problem 1.4

In a study conducted by the Department of Mechanical Engineering at Virginia Tech, the steel rods supplied by two different companies were compared. Ten sample springs were made out of the steel rods supplied by each company and a measure of flexibility...

In a study conducted by the Department of Mechanical Engineering at Virginia Tech, the steel rods supplied by two different companies were compared. Ten sample springs were made out of the steel rods supplied by each company and a measure of flexibility was recorded for each. The data are as follows:

Company A: 9.3 8.8 6.8 8.7 8.5 6.7 8.0 6.5 9.2 7.0 Company…

View On WordPress