IT LIVES!!!!! So story time. Bought a 3D printer (Ares by easyarts) on Indiegogo and received it about 3 years ago. If I remember correctly (which is a bit hazey cause I don’t have sufficient storage space in my memory) I got the printer, set it up and got stuck cause I honestly could not get the pla tube to fully pass through the feed. Also when I set up was overly excited, AS YOU WOULD, when your making cosplay and invested in a 3D printer with diddly squat of computer knowledge (think in terms of setting the vhs/vcr for your parents where I am now that parent that doesn’t know shit). So tried to configure it as best as I could make heads or tails of how to set this up at the time. Which at the time was a hard time finding a help forum about a non standard 3D printer. So it got stored away for a bit and hadn’t touched it till I found it and found a g+ discussion forum which helped out a bunch and NOW IT LIVES!!!! Next step, how to set up a camera for the scanning application and what to print out