May 24, 2020
#grizzlymill #grizzlymillingmachine #manualmill #evaderknives #dailygrind #handmade https://www.instagram.com/p/CAjaFkJjOud/?igshid=efnhe4kbuom5
seen from Malaysia
seen from Indonesia
seen from Germany
seen from Czechia
seen from Canada
seen from China
seen from Brazil
seen from Morocco
seen from Malaysia
seen from United States
seen from Netherlands
seen from Brazil
seen from Iraq
seen from Malaysia
seen from Yemen
seen from Malaysia
seen from Australia
seen from United States
seen from Türkiye
seen from Germany
#grizzlymill #grizzlymillingmachine #manualmill #evaderknives #dailygrind #handmade https://www.instagram.com/p/CAjaFkJjOud/?igshid=efnhe4kbuom5
Cleaning up the mill & crashing for the night... #millingmachine #grizzlymill #knifemaker #evaderknives (at Fairfax County, Virginia) https://www.instagram.com/p/ByMEdPgniEG/?igshid=xnr9bypmp1gz
Another corner of the #workshop cleaned... #shoplife #knifemaker #evaderknives #grizzlymill #grizzlylathe (at Fairfax County, Virginia) https://www.instagram.com/p/BswyKHDBH_U/?utm_source=ig_tumblr_share&igshid=1xim07r1cfccf
The stops are done for the #grizzlymill. I used the knob off the extra handle for more control. #EvaderKnives #machiningnoob #machining #powerfeed #knifemaker (at Vienna, Virginia)
I fought this #power feed tooth & nail, but FINALLY!!!! It WORKS!!! I must say stacking 2x4 and using a ruler to level is one of those fine line between madness/genius, but that also worked great!!! Now I just have to install the stop. #EvaderKnives #machining #machiningnoob #grizzlymill (at Vienna, Virginia)
I fought this #power feed tooth &a nail, but FINALLY!!!! It WORKS!!! Now I just have to install the stop. #EvaderKnives #machining #machiningnoob #grizzlymill (at Vienna, Virginia)
I'll tell ya what this little bearing cover on the #milltable is fighting every bit of the way. I did figure out, if you use the hex bolts off of the #power feed panel(basically any of the small #grizzly silver Allen screws, they are on everything ) & screw them into the pins holding the end pieces, the pin comes right out. So close yet so far. #EvaderKnives #knifemaker #machiningnoob #grizzlymill
So I figured while I was at it, I would cut out some protection for my #grizzlymill table. It'll also make cleaning up easier. #Carpentry #knifemaker #EvaderKnives (at Vienna, Virginia)