Pallet Jack Repair Instructions
Any company that receives deliveries can most likely take advantage of getting a pallet jack around. A pallet jack is really a device having a by hand operated hydraulic lift and wheels where you can lift and move wooden, plastic and metal pallets and skids. From time to time something goes awry using these helpful products, therefore it is best to know repair them.
Wheels and Axles
The simplest areas of a pallet jack to examine, repair or replace would be the wheels and axles. You will find two teams of wheels, the burden wheels and also the steer wheels. The burden wheels are underneath the fork. These wheels ought to be looked over regularly for put on and damage. Any size reduction greater than a quarter inch, or flat spots, warrant alternative. Pump the curler handle to reveal these wheels. Then turn the jack on its side. The axles are often locked in with curler hooks. Punch these by helping cover their a pin punch and hammer. Switch the bushings, what are tubes of brass or copper separating the axle in the wheel.
The steer wheels they are under the pump handle. Inspect these wheels for put on, and replace if required. The axle to those wheel is generally locked in having a snap ring you will need snap ring pliers to get rid of it and install a replacement. These pliers can be found at auto technician supply shops. Just like the burden wheels, switch the bushings when you get the opportunity. Bushings are intended to be expendable.
Push Rods and Lifting Links
The push rods and lifting links would be the parts that connect the hydraulic unit towards the load wheels. Inspect them for bends, cracks and out-of-round holes, and replace if these conditions exist. These parts are usually locked in with curler hooks punch the hooks having a pin punch and hammer.
Hydraulic Unit
Test the hydraulic unit by placing the jack within load and moving the handle to lift it. When the jack doesn't lift, look into the handle linkage towards the hydraulic unit. When the jack lifts, allow it to take 15-20 minutes. The burden shouldn't have dropped for the reason that time. Whether it has, you might have a leaking hydraulic unit. Look into the fluid level and refill it by decreasing the jack and flowing in hydraulic oil through the filler plug. Don't overfill, as this makes leakage and harm to the pump.
Some producers sell seal kits so that you can rebuild the pump yourself, or else you may decide to exchange your broken pump for any reconstructed or brand new one.