seen from United States
seen from Hong Kong SAR China
seen from Netherlands
seen from Malaysia
seen from United States
seen from United States
seen from Singapore
seen from Türkiye
seen from United States
seen from United States
seen from United States
seen from Ukraine
seen from Serbia
seen from Ukraine
seen from Greece
seen from Germany
seen from United States
seen from South Africa
seen from United States
seen from United Kingdom
Starting my next #3dprinted #project .its a #toyota #22r #engine printed with #red #plafilament on my #mpminiselect #3dprinter . This is just the #engineblock so I have lots mor parts to print and assemble, but I will post them as I assemble it. #3dprinting #geek #geekyart #creativeart #nerdy #engine #mechanicalart #carparts #cars #automotive #automotiveart #gearhead #guystuff
Here’s a picture of all the ##luckycat #3dprinted figures I have printed using different colored #plafilament from smallest in the front to biggest in the back. #3dprint #3dprinting #3dprints #3dprinters #mpminiselect #3dprintedart #3dcat #geek #geekyart #nerdy #geekystuff #nerdystuff #creativeart
My latest creation on my #mpminiselect 3D printer. Very happy with the results. I have more colors of filament coming in today and I can’t wait to change it up. #3dprinting #buddha #3dprinter #3dprinted #geek #yinyang #balance #bestwifeinthegalaxy
#snowman done in blue #plafilament. My #wife loved this one as well. Next project will be a Viking helmet done in bronze filament #3dprinting #3dprinter #3dprints #3dprint #3dprinted #bluesnowman #letitsnow #holidays #holiday #holidayseason #geek #geekystuff #nerd #nerdystuff #mpminiselect #art #printedart #bestwifeever
Created this yesterday evening for my #raspberrypi. I think it turned out pretty good. #3dprinting #raspberrypicases #geek #mpminiselect #nerdy #minicomputer #creativeprinting #learning
Prints are getting more critical, now that I’ve (I think) dialed in the printers, I want to make sure I’m using the optimal temperature. Sometimes you think it prints fine but the adhesion between layers is bad and causes separation under stress because it didn’t heat enough to melt the filament optimally. My first thought was to use the least amount of temperature to avoid overheating and causing blobs and burnt filament but now I think it is better to start with a higher temperature and adjust downwards. Reviewed the final piece and for this #hatchbox black printed on the #mpminiselect 205C seems to be the best although most temperatures are fine with subtle blobbing at 220C which is the upper limit of the recommended temperature. #3dprinting https://www.instagram.com/islandcaptureny/p/BxD8F88AW0C/?igshid=5wqdhetjuotj
While Project Orange is busy printing a Moai, Small But Not Terrible is pressed into service to make something for Easter. #3dprinter #mpminiselect https://www.instagram.com/islandcaptureny/p/BwbIIa0gMZ9/?igshid=1rlc7qdwx4aru
#octoprint is online. I still have to configure the camera. #octopi #3dprinting #mpminiselect https://www.instagram.com/islandcaptureny/p/Bvx3dvlgje8/?utm_source=ig_tumblr_share&igshid=1tjclx9ckz4vw
