How Much Does it Cost to Install Pavers?
Following the market trends in 2022, an average patio paver installation in Tampa, Florida, can cost about $8,302.80 for a 400 sq ft area.
The cost of a paver installation in Tampa, Fl, can range between $10 and $25 per square foot. This price is highly dependent on your location and your paver installation company. We will help you determine the total cost of a Tampa paver installation by putting together a comprehensive price guide. This guide will be based on an average estimate for 400 square feet of paver installation.
Paver installation costs can be divided into 5 (five) parts as below:
The cost of materials can be further divided into 6 (six) parts, namely
Usually, a concrete paver can cost between $3 to $6 per block. Brick pavers come in two types: the lower-end variants cost between $4 to $8 per square foot, while the higher-end variants can cost up to $15 to $20 per square foot. Stone pavers are made of natural stone or made to imitate natural stone. They can range from $7 to $16.
Making necessary adjustments, the approximate cost of pavers for 400 sq ft would be around $1,534.89.
This base is made from crushed rocks, ranging from fine dust to ¾” stones. The cost of a Class II Road base varies significantly depending on your location; however, it can get as low as $0.73 per square foot.
For 400 sq ft., the cost would be $292.
A layer of geotextile fabric can cost about $0.43 per square foot.
For 400 sq ft, the total cost would be $172.
Bedding sand is a cushion between the class II road base and the paver blocks or stones. This will cost about $0.36 per square foot.
For 400 sq ft, the total cost would be $144.
Concrete is used in several ways to install pavers, but it is mostly used to reinforce the borders. Concrete costs roughly $1.33 per square foot.
For 400 sq ft, the total cost will be $107.
Joint sand is used to fill the joints between pavers and helps keep the pavers level and in place. It costs about $0.12 per square foot.
For 400 sq ft, the total cost will be about $4.80
This brings the total cost of materials for a 400 sq ft paver installation in Tampa, Fl, up to $2,255.30.
Operating costs comprise several smaller fees, such as.
To construct a 400 sq ft paver installation, roughly two and a half trucks of concrete and half a truckload of dirt are required. One dirt load costs approximately $160, while one load of concrete costs about $121.
The total dump costs amount to an average of $261.50.
Fueling costs can be hard to gauge, as it differs in every case and every location. It also highly depends on the fuel prices and the distance the materials need to be hauled. Therefore, fueling costs would be about $500.
Depending on the manufacturer and distance, the delivery prices can vary from $520 to $670 per trip. Since 400 sq ft of pavers need to be delivered and one load can haul 1,400 sq ft, the cost of one haul can be estimated at $550.
Pallets usually cost about $0.09 per square foot. Hence, for a 400 sq ft project, a total can be estimated at around $36.
The leftover material after construction has been completed needs to be picked up. This fee would be about $225.
The cost for excavation can range from $0.47 to $2.28 per square foot. However, we can assume an average $1 per sq ft rate. The total for a 400 sq ft area would cost $400.
This brings up the total operating costs to $2,202.50.
The most significant factor that influences the price of a paver installation is labor cost. When choosing a paver installer, it is not recommended to pick the cheapest alternative. Instead, you should always select one with the most experience.
An experienced paver installation company can charge between $5.53 to $8 per square foot.
Depending on the quality of the installation crew, your labor charges for a 400 sq ft area can range from $3,200 to $2,140. However, we will assume an average price of $6.01 per square foot, which brings the total up to $2,404.
The overhead depends highly on the project; we can assume a 10% overhead.
Considering the cost laid out so far, the overhead will be 10% of $6,861.90, which brings the company overhead charges up to $686.18.
Depending on the service provider, a paver installation company can have different profit margins, starting from 10% up to 40%.
Assuming a profit margin of 10%, the total company profit amounts to $754.80.
Following the market trends in 2022, an average patio paver installation in Tampa, Florida, can cost about $8,302.80 for a 400 sq ft area.
