#printfail

[kaxenart]

My first spaghetti incident of the horse print. Loose filament tangled itself on the BL touch probe.

=_= I should have stopped the print when I noticed one wall was uneven...

But I have a pencil jar? small planter? now

At least it didn't fail while I printed the horse's bits. I have no idea how I would repurpose a horse's balls. lol

[robot-scarecrow-blog]

11 hours into a 15-hour print, the filament spool fell off the printer. Argh. #3dprinting #printfail #cosplay

[saritaonline]

So I forgot my passport copy at home. And I badly needed it for an errand. So since I was already at the mall, I went to @officewarehouse sa @venicegrandcanal to print it out for me. And they were so helpful and printed it out with their wireless printer from a digital copy on my phone. ANG DAMI KONG TAWA PAGPRINT! 😂 Lahat din ng tao and staff sa Officewarehouse at that time, tawa ng tawa! Kalokahhh! 🤣🙈 next time, sa tarpaulin ko na ipapaprint to. 😂✌️ #printfail (at Venice Grand Canal, Mckinley Hills) https://www.instagram.com/p/Cl5ktWEu2ha/?igshid=NGJjMDIxMWI=

[the3dsmith]

After some successful prints in yesterday, today the extruder started clogging with the yellow filament. Switched to red and was able to print the nozzle box. Now I’m back to yellow for another attempt... more to come! . #the3dsmith #3dprinting #trialanderror #printfail #yellow #red #3dfilament (at Netherlands) https://www.instagram.com/p/CBqvHjSjE7n/?igshid=1xc4nu9cqou5i

[blitzcitydiy]

The bulbasaurs had some difficulties this evening. Pikachu judges in the distance #diy #tech #3dprinting #pokemon #bulbasaur #pikachu #lowpoly #printfail #make #makersgonnamake #makersmovement #nerdlife

[parkesprint-blog]

Anyone for some orgasmic blueberries?

Check out our latest Pinterest board featuring some rather unfortunate hilarious examples of human error.

[hughqelliott]

My asshole 3D Printer

I bought a 3D printer a couple of years ago. Split the cost with a co-worker and we did a couple of prints. He became disinterested and I bought him out.

I’ve had nothing but issues with it. First was hot end jamming. I cleaned the hot end multiple times and felt defeated. Then a friend suggested I switch filament. I did and what do you know? Fixed. Now I get lift issues. The corners consistently lift. The same friend, coincidentally with the same printer, has now recommended I haven’t properly leveled the heated bed. This is entirely likely.

I’m going to spend serious time dialing in this printer because I know it can do good prints. This is my fault. I get impatient and do only a so-so job in setting it up.

Libs this morning asked “what would a good 3D printer cost?” Her reaction when I said “a couple grand” was priceless. That’s right, I’ll give this one more chances because it’s expensive to replace.

[spaghettibot]

via Markus Hartel