Thermoflex Ref-Lite Safety Reflective Iron-On Vinyl
I ordered some of this from Amazon.com and thought I had good settings but they cut clean through the material. After several test cuts I decided that these settings were good. A thickness of 4 also works, but I had some spots that didn’t cut through. A thickness of 6 cut too much, even through the support plastic.
As a side note, there is a film covering what will be the back side of the material. Remove it before cutting, it’s a nuisance to remove after.
I used a regular iron to apply, pressing firm through card stock for about 20-30 seconds. I found it beneficial to wait 30-60 seconds before pealing off the support plastic, otherwise a residue may be left behind.
Blade: 1 Speed: 8 Thickness: 5