Car Headrest Bag Hooks
The Car Headrest Bag Hooks design is similar to some commercially available... but unlike other designs, this is made in a way that this cannot be accidentally detached/unhooked from the heat rest posts due to the way it assembles. Headrest Bag Hooks are a great solution for your own use but will also be appreciated by many people as a practical gift for everyday use. Before starting you will need to measure your car's headrest seat posts to decide which Bracket and Spacer to download and print. Most cars will use the (up to) 15mm. Assembly and fitting are easy, as follows: (1) Raise the headrest in your car so the U shaped Bracket can be pushed onto one of your headrest posts (2) Insert the Spacer to close off the open end of the Bracket (3) Slide the Centre section through the Bracket and Spacer until it is centered (protrudes out of the Bracket equally on each side). You will need to align the flat surface of the Centre section with the flat surfaces inside the holes in the Bracket. (4) Slide two Hooks onto the assemble (one on each side) (5) Screw one Bolt into each end of the Centre section and tighten. (6) Make sure the hooks can still swing freely and individually in the Centre section. (7) Lowering the headrest is suggested as this will reduce how much the assembly can move around in use. (8) Place one or two bags onto the Hooks as required... Read the full article