Launch X431 IMMO Plus Program Suzuki Alto Key by OBD
This is a tutorial on how to program the Suzuki Alto key with Launch X431 IMMO Plus by OBD. The procedure includes 3 steps: read the PIN code, program the key with PIN, and register the key. As for X431 IMMO Elite or IMMO PRO can follow the same way for key programming.
Step1. Read Pin Code
Connect X431 IMMO Plus to OBD port.
IMMO >> SUZUKI >> Anti-Theft Password Reading >> 8 Digit PIN >> Input 20 digit ID code(ID code can be read from key programming menu)
The PIN result is: B614AC78
Remember the password.
Step2. Program Key with PIN
Select from area >> India >> Alto >> Type 3(KLS 8 digit PIN) >> Program keys with PIN
This function allows you to read the ID code stored in the immobilizer system, and turn on the ignition switch.
Press "OK" to confirm the ID code.
This function is used to check the current condition of immobilizer registration and to register the immobilizer key Etc.
Perform the following operations according to key types:
Mechanical key: turn on the ignition switch with the mechanical key to be matched.
Intelligent key: attach the Micro-label position of the intelligent key to be matched to the start button.
Knob-type intelligent key: insert the smart key of the intelligent key into the knob lock cylinder, and put the intelligent card close to the knob switch.
Please input the security code(8 digits).
Note:
Before performing "Immobilizer Key Registration", make sure that the key is inserted in the key cylinder. If the key is not inserted, click the "Cancel" button and insert it in the key cylinder.
For the vehicle with the engine switch(Start/Stop button), make sure that the remote controller is inside the vehicle.
For the vehicle with the engine switch(start/stop button), do not turn off the ignition switch during immobilizer registration!
Step3. Register Key
Click "Immobilizer Key Registration".
Important!
Previous vehicle information will be totally cleared.
Prepare all transmitters or remote controllers for registration.
Previously registered information will be cleared.
Register the transmitter or the remote controller.
For the vehicle with the ignition switch, click the "OK" button to go to the next step.
For the vehicle with the engine switch, hold by applying the remote controller to the engine switch, and then click the "OK" button.
The transmitter or the remote controller has been registered.
Click the "OK" button to register another.
Click the "Cancel" button to finish the immobilizer registration.
Prepare another transmitter for the next registration.
After replacing it with another transmitter, turn on the ignition switch.
When selecting "Immobilizer Registration" from the menu, execute "Read ID Code" again.
Program successful.
