How to use stepper motor with arduino in proteus
Arduino bipolar stepper motor speed and direction of rotation control with L293D driver - Proteus simulation.
Bipolar stepper motor speed and direction control with Arduino
stepper motor driving with arduino UNO and L293 driver in proteus
Speed Controll by Potentiometer
.............................
Hardware Required:
Arduino UNO board Bipolar stepper motor L293D motor driver chip 10k ohm potentiometer Pushbutton Power source with voltage equal to motor nominal voltage Bread board Jumper wires
.....................................
The 4 inputs are connected as follows: IN1 to Arduino pin 8 IN2 to Arduino pin 9 IN3 to Arduino pin 10 IN4 to Arduino pin 11
.........................................
The 10k ohm Potentiometer is used to control the speed of the stepper motor, its output pin is connected to Arduino analog pin 0.
......................................
The push button which is connected to Arduino pin 13 is used to change the rotation direction of the stepper motor.