$LAYYYTER
Origami Around
PUT YOUR BEARD IN MY MOUTH
@theartofmadeline
occasionally subtle
#extradirty
Sade Olutola
I'd rather be in outer space 🛸
official daine visual archive
Today's Document
oozey mess
YOU ARE THE REASON
RMH
Interview Vampire Daily
No title available
PR's Tumblrdome
No title available
Product Placement
h
roma★
seen from United Kingdom
seen from Bangladesh
seen from United States
seen from Türkiye
seen from Malaysia
seen from Ukraine
seen from Italy
seen from Morocco
seen from United States
seen from Venezuela
seen from Malaysia
seen from United States
seen from Belarus
seen from Malaysia
seen from Malaysia
seen from Türkiye
seen from Türkiye
seen from Colombia
seen from Brazil
seen from United States
@hanseaticsurfer
Christian from Bonsaimachos.de suspects error -10305 being raised in a bunch of cases, eg. encryption settings (WPA/WPA2), firewall settings, android/ios issues and so on... German speaking MusicCast can check his website for more usefull hints.
Run Yamaha MusicCast after Network Change
Hi folks!
I spent lots of evenings trying to find out how to get rid of error 10305 in order to re-setup the wifi network for my MusicCast components after substituting my wifi router (which now uses slightly different security settings compared to the older one).
Finally, I figured out how to get through the setup process of the app without facing any errors. This is how it worked for me...
1st Step: Factory Reset of Network Settings successfully tested for devices WX-010 and WX-030
According to Yamaha FAQ conduct the following steps not documented in the manual:
While device is turned off press and hold the ‘Volume -' & 'Volume +' buttons on the top panel at the same time for about 5 seconds
Then press the Power/Connect button on the top panel for about 3 seconds
The network settings are now reset back to factory settings.Â
2nd Step: Re-Setup the Network within MusicCast Controller App
Remove any old room settings (resp. room entries) as they hold information of the previous network
Perform the ‘Connecting to the network’ steps according to the user manual of your device (e.g. in case of WX-010 see description on page 7), but...
Do not select a suggested network, scroll down instead and select 'Other SSID’ (or similar) and type in the SSID of the network you want to connect with, manually
As soon as you have entered the network SSID manually, you will be asked to specify the security settings of your network (e.g. you can select ‘WPA2′ or ‘Mixed Mode’, the latter is labled ‘WPA+WPA2′ by some router configuration masks)
In my case, these steps successfully helped not facing any errors. Afterwards, I was able to continue with setting up the room name etc.
If this helps you as well, I would be happy if you buy me a coffee in return! ;)