Battery Packs Installation Ways
1. Detach ground and positive cable connection with main battery.
2. Clear away back cover right from TRUE Smart Battery Isolator.
3. Link a single red cable to one lug within the back.
4. Connect the other red wire to another haul.
5. Make sure the cabling and black ground wires are all getting out of the SBI throughout the available slots.
When you are planning to place the SBI together with the 3M dual lock product attach the trunk cover with the nuts and screws provided anchoring screws getting through the rear and the nuts will pull down straight into the openings around the front. Remove the adhesive covering on one side of 3M dual lock and press product firmly to back cover. Apply an opposing side in the same manner to your chosen mounting surface area. If you are setting up the SBI together with the screws next install the back cover towards your chosen location by drilling little pilot slots in the mounting surface area on two reverse corners with the rear cover and employ the shorter sheet metal screws to connect. Once it's attached drill pilot slots inside additional two holes and mounts the SBI with the extended screws going through to the front of the SBI inside the pilot holes.
6. Connect one red card to the positive terminal of each battery.
7. Link the Black cable between the two negative terminals of the batteries.
8. Connect the small black surface cord on the SBI to one of the negative porters or a common ground.
9. Hook up the major battery again.
10. Get started your car and confirm all is working properly (bear in mind it will take a few a few minutes for the primary battery to arrive at activation level after starting up).
These ATV/UTV Dual Battery kits are perfect and due to the fact they include a high end large capacity TRUE Smart Battery Isolator they are able to actually be used for your boat, vehicle or wherever your two batteries have been around in proximity to each other.
