Designed a #nametag for a lady at my favorite taco shop. It's a gift for her and she doesn't know I made her one. =) #3Dprinted in @faberdasher Punk Star Pink and @proto_pasta #CFPLA. I hope she likes it. #rhinestones #sparkles (at Gresham, Oregon)
seen from Belgium
seen from Poland

seen from Sri Lanka

seen from United States
seen from China
seen from Türkiye
seen from United States
seen from Belgium
seen from United States
seen from United States
seen from Estonia
seen from China

seen from France
seen from Belgium
seen from China
seen from United States

seen from Malaysia
seen from United States
seen from China
seen from France
Designed a #nametag for a lady at my favorite taco shop. It's a gift for her and she doesn't know I made her one. =) #3Dprinted in @faberdasher Punk Star Pink and @proto_pasta #CFPLA. I hope she likes it. #rhinestones #sparkles (at Gresham, Oregon)
Snap joint test. Some things are coming together. Calibration box is there for support. I've been at the drawing board, or rather slowly learning Fusion360 this spring and hoping to have some files ready for release later this summer. #3dprintedspeakerenclosures #cfpla @proto_pasta
😍 Dat finish doh, 😍@proto_pasta #CFPLA 💞💖err mer gurr💖💞 Luxury Top Shelf #filament, #3dprinting #MazandAttero #ProtoPasta #DIYprinter #reprap #pdx3dplab @pdx3dplab #3Dprinted
#daytonaudio category just wrapped up at the #midwestaudiofest My entry were the 7+1 TM design with 7" Dayton Aluminum Woofer and 1" soft dome tweeter. Enclosures printed in @proto_pasta #cfpla and #sspla on the #mendelmax3 (at Parts Express)
Good morning from the #midwestaudiofest meet my final project from my MFA, the MFA-3DP-SL3 (Master of Fine Arts - 3D Printed - Sphere Line-array three-way) Materials: @proto_pasta #cfpla @colorfabb_official #bronzfill @hatchbox3d #pla #3dprinters : @gcreate3d #gmax1.5xt and #makerstoolworks #mendelmax3 (at Parts Express)
Just finished some late night, last minute polishing of @colorfabb_official #bronzefill Painting also occurred on some other prints to match the @proto_pasta #cfpla Getting ready to go to the #midwestaudiofest
Assembly in full swing at the @um_media_arts Grad Lab. Showing scale with two sections from midrange line with a single section from one of the three low frequency drivers. On the left: #hivi #b3n in a @proto_pasta #cfpla and @colorfabb_official #bronzefill enclosure. On the right: #daytonaudio 8" in a #hatchbox enclosure printed on the @gcreate3d #gmax1.5xt+ (at University of Montana)
#dualextrusion - bringing fine filament together. @proto_pasta #cfpla #sspla (at University of Montana)