#bltouch #autobedlevel #mendelmax3
seen from Argentina
seen from Argentina
seen from China
seen from China
seen from United States

seen from United States
seen from Australia
seen from Japan

seen from United States

seen from United States
seen from United Kingdom
seen from United Kingdom

seen from Malaysia
seen from United States

seen from Malaysia
seen from United States
seen from United Kingdom
seen from China
seen from China

seen from United States
#bltouch #autobedlevel #mendelmax3
A view that has been missing from my feed for the past few months. Currently printing some parts for new upgrades on the #mendelmax3
#daytonaudio category just wrapped up at the #midwestaudiofest My entry were the 7+1 TM design with 7" Dayton Aluminum Woofer and 1" soft dome tweeter. Enclosures printed in @proto_pasta #cfpla and #sspla on the #mendelmax3 (at Parts Express)
Paint dry. Crossovers mounted. Big prints from @gcreate3d and the #mendelmax3 ready for drivers and a drive. See you at the #midwestaudiofest
View from the top. First thick layer of @proto_pasta #cfpla via @microswissllc .8mm nozzle, #e3dv6 on the #mendelmax3 Last minute printing on another #3dprinted entry in the #midwestaudiofest (at University of Montana)
Some of the nicest surface finish I've seen yet from @proto_pasta #cfpla from the #mendelmax3 (at University of Montana)
#kisslicer throwing some curveballs at this. Will be opting for slower speeds in in tomorrow's print. Only had it maxed at 80mm for perimeters and 60mm for infill, which has been ok on the #mendelmax3 Previously my go to settings on the #mendelmax2 were 60mm perimeters and 45mm infill. (at University of Montana)
First @ninjaflex3d test complete on the #mendelmax3 (at University of Montana)