#decorating the case

[zhalfirin-binds]

Case decoration

This time I made a plan with a drawing and notes on the distances and all!

And then I failed on following through on both cases. I set the second short line of the box on one case the same height as the upper one (it was supposed to be a bit higher) and then it was done and all I could do was following through with that setting. It's not what I aimed for and there are a few other small mess ups, but I like it anyway.

(look at the upper left corner of the left box in the left case, the lines don't end neatly. Also, again left case, outer long line in the left box, I had to hot stamp twice with the same line and move the case a bit to get the whole length. On that line you see how both lines do not overlap as they should and the upper part is a bit too wide and the end of the line is visible)