Bissell Dirtlifter Powerbrush Operating Instructions
Carpets and area rugs holds onto stains. You are able to remove these stains debris using the Bissell Dirtlifter PowerBrush. Before operating the device, move furniture taken care of and intend to provide your carpet 2 to 3 hrs to dry before walking it. The device requires water warm water is efficient at helping to loosen stains. Permit the plain tap water to warm up before adding it towards the machine.
1. Vacuum carpeting before while using Bissell Driftlifter PowerBrush.
2. Press the handle release lever on the rear of the shampooer together with your feet. Lay lower the handle.
3. Pull the tank through the handle from the bottom of the device.
4. Rotate the handle around the tank toward take away the lid. On the sink, turn the tank over and look for the built-in calculating cup.
5. Pour carpet shampoo formula in to the calculating cup as much as the fill line. Then pour the items in the cup in to the tank. Switch the cup into the tank.
6. Fill the tank with clean, hot plain tap water. Stop filling once the water reaches the tank's fill line.
7. Switch the lid around the tank and rotate the handle to secure it into position. Put the tank back onto the bottom of the device. Make certain the tank is safe within the base. Slowly move the tank handle in to the locked position. Then pressure the device handle into its upright position.
8. Plug the Bissell PowerBrush right into a energy outlet. Switch on the energy switch.
9. Press the handle release lever together with your feet to regulate the rear handle.
10. Press wartrol trigger beneath the handle to spray the solution. While pressing the trigger, slowly move the shampooer forward gradually within the stain.
11. Pull the shampooer backward within the same place to suck in the loose debris. Do this again until stain or grime is taken away.
Don't oversaturate carpeting.
Don't use boiling water, only hot plain tap water.
