Long and Heavy Ropes - Prepping for Texas Skip
A weighted honda was an unfamiliar thing to me until recently. I taped a few pennies on one of my smaller ropes months ago and didn't notice a big difference right away, later as I switched between ropes I could tell a subtle difference, and I started liking a little extra weight. A few pennies is small change though when it comes to honda weight, that would only be applicable to smaller ropes to do flat loop and butterfly tricks. Those aren't heavy ropes, just light ropes that have been "balanced" to taste. There is another breed of rope that has a different purpose and feel; heavy ropes that are good for large vertical loops and large wedding ring tricks, but the number one attraction seems to be the Texas Skip. I've seen a few Texas Skip videos and read a few brief tutorials but I haven't seen a lot of detailed accounts on the subject of transitioning from light ropes to heavy ropes so I hope to share something meaningful from my experience. I'm not intending to move away from light ropes of course, I love those ropes. I'm just expanding my repertoire.
The video below demonstrates most of what is discussed in this entry.
Video: Adventures In Trick Roping - Long and Heavy Ropes
I have a 25 foot length for a long skip rope but I haven't put a brass honda in it yet, I'm experimenting with just tying a big fat honda on it which upon first test does well for large wedding rings but I don't think the weight of the knot is quite enough for the large vertical loop needed for skip, I'll probably transition to the traditional brass honda soon.
Photo: A simple but effective tied honda.
Before going to a 20+ foot rope, I dive in with my 18 foot rope that used to seem too long and floppy so I hardly used it, that's before I added weight to it though. A month ago I put in a metal thimble and now it's a different beast. I just picked up an off the shelf 3/8 in rope thimble from the hardware store and taped it in snug to try it out, figuring that if I liked it I could sew it in later. I’m pretty sure at this point that I will sew it in permanently.
Photo: Honda weighted by a metal rope/cable thimble.
The first thing I noticed when spinning this rope is that I really had to crank it to get a good loop to open. I can do a horizontal loop with a moderate to large loop diameter. Sustaining a small loop with a heavy honda does not seem to work for me, I didn't expect it to work but just wanted to try it out. The weight has a tendency to close the loop on you quickly, especially when your loop size is smaller. It's clearly more of a workout with your arm and shoulder to spin these loops, you will feel it. Even with the weight, a loop will still open up bigger when you accelerate enough so you can start at a medium size and work up to a big loop. Be careful though, you can still get to a point where the loop will ride up your spoke and if you've got no more rope to let out the loop will lose its circular shape and at that point and start flopping around which could get dangerous. There's more rope and more weight, in addition to sometimes faster speeds so it packs more of a wallop when you smack yourself with it. I've gotten hit in the face and other sensitive ares when working with light ropes, and I really want to avoid that with a weighted honda. That aspect brings a new fear, and fear is prohibitive to development. We should keep ourselves safe, but also take appropriate risks. Tread slowly enough at first to build some confidence, then ramp it up to try new things and open yourself to improvement. It didn't take too long to get used to it, I haven't smacked myself yet but I'm sure it's inevitable. I’m happy to risk it, they used to call me Danger Boy after all.
It can get uncomfortable to spin a large flat loop, heavy or not, the positioning of a vertical loop is probably easier on your posture because you don't have to worry about keeping the loop away from your shins but the spinning feel is different for a vertical loop as gravity is working with the honda half the cycle and against the honda the other half instead of equally all the way around like with horizontal loops. I started with a medium size flat loop and tilted it up into a horizontal loop to get the vertical loop feel. Then I tried starting right into a horizontal loop. The start takes some getting used to, there's no quick secret trick to it that I can share, you just have to start cranking. I did have some starts where the rope got all tangled up in my arms right away, I think it might be a question of how fast and how big of a circle you swing your arm from the start, but I don't know exactly. From the start I experimented with spinning direction, a few items of clarification are in order on the subject of spinning direction. Standard "forward" butterfly uses a counter clockwise loop when it's on your right side but will then be a clockwise loop when it's on your left side. Of course the loop doesn't change spinning direction, it's just that your perspective changes as it passes from one side to the other, just like someone on one side of a door says the knob is on the left while someone on the other side of the door says the knob is on the right. The standard Texas Skip loop however uses a clockwise loop when it's on your right side but it becomes a counter clockwise loop on your left side so it's more akin to a reverse butterfly in the direction of spin. That's the convention, it's supposed to be a little easier that way but I can't say from any experience yet. I know that when I try reverse butterfly it feels strange and hard to spin it that direction, but maybe just because it's different than what I'm used to.
One of the first things I wanted to do after getting a little feel for a stationary vertical loop was transitioning from a vertical loop into a wedding ring. This one is not a lift-on but a gradual tilt of the rope till it's in the horizontal position. I thought it shouldn't be too difficult of a trick, and I was mostly right but I'm not quite solid on it every time. I had a few wobbles and instances of getting tangled up in it but in a short time I had success too. My main focus was in smoothing out the loop as it transitions. I started the vertical spin in a clockwise direction with my right hand, built up the loop a little and then started tilting. It wasn't so steady for me in the in the transition and I think that the speed of your spin is very critical. When it goes horizontal it feels like you can ease up a bit compared to what you need to keep the vertical loop going. It's just a new, unfamiliar feel but I'm getting used to it. You can start your vertical spin in the other direction (counter clock wise) but mind you, when it falls to a horizontal loop it will then be going in the opposite direction from what most people are used to for wedding ring. While in training, you may quickly feel the muscles straining in your shoulder and want to alternate between left and right arms to balance it all out, that's what I did and my left arm was actually pretty good out of the gate.
The next little step was going from flat loop, to vertical loop, to wedding ring. Which is really just putting two things together that I already did so I found it not really any more difficult. It's interesting to consider that this works with a heavy honda, but now if you pick up a light rope and try this you will likely get it into a vertical loop for a few seconds and then it goes all wet noodle. Now I see why we have weighted hondas. So I then started thinking about doing the trick in reverse order? From wedding ring tilting into a vertical loop, I tried it a few times (with a heavy rope of course) and it didn't feel easy but I got it to work once. I haven’t tried it since because I don’t want to tarnish my record. ;)
I then decided to try some horizontal loop tricks with a heavy rope. Flat loop, step in, wedding ring, handshakes, spoke hops, lift-off, and even lift-on were all do-able while keeping the loop size in check. Some of those tricks felt quite different with a large heavy rope but I want to keep working them so I have the option to make a continuous routine going back and forth between horizontal tricks and vertical skip tricks.
Here is an interesting question: can you do the butterfly with the heavy rope? and my answer is for practical purposes no. To keep the movement of the rope manageable in front of you it's best to not have too big a loop for butterfly but these heavy ropes work best with bigger loops it seems, so that's against you, the loop closes up and you end up fighting it pretty hard to try to keep it open. Try it if you want a difficult physically intensive challenge, let me know if you have success. Now a medium weight rope would probably be a yes for butterfly but I’d steer clear of it with heavy ropes.
I turn now to Texas Skip from my beginner's perspective. I've heard it's not quite as hard as the butterfly, and I can do at least a passable butterfly at this point so I have some confidence going into this but I've got to tell you, once I see that big spinning loop next to me, skipping through it does not come too natural. But one nice thing about these ropes is that if you spin the right speed and motion, you can spin a stationary vertical loop for as long as your arm holds out and you can stare at that spinning spoke for as long as you like while contemplating jumping through. The loop will hold there till you're ready to jump through, compare this to learning butterfly and you've got to keep that loop moving left to right and back, you can't easily stop and hold the loop on one side till you're ready to bring it back to the other side again. Maybe you're better at coaxing your butterfly to stay put but mine loses shape if I try to hold it on one side for more than a few spins. For me, it feels easier to jump through when I'm turning the rope in the opposite direction from the standard skip. A counter clockwise loop on my right side seems easier to jump through from a timing perspective than a clockwise loop. I haven't really tried very much yet but I'm just backwards I guess.
My skip was not immediately feeling smooth. I did make it through the loop sometimes as you can see in the video, and I don't always lose the loop after I go through it but I can't keep skipping through multipe times and what I've got isn't pretty, it's a struggle. This first rope I'm trying is smaller than standard which probably causes some issues, but I'm sure that's not the source of all my issues. I've only spent a few sessions trying this trick out, so right now I just need to spend more time with it, review some video of my flaws and work to correct them one at a time.
Photo: Jump Through Sequence with 15 ft. rope.
I think that the reason why I feel more comfortable spinning the rope in the "other" direction for skip is because that's how I did the jump-through trick from my younger days (see the first blog entry: Choir Boy Beginnings) and it's hard for me now to approach this trick as something different, but I feel it should be considered as such. The Texas Skip as I see it performed by others looks very different to me than my old jump through trick and not just because of the differences in the rope used. During skip the rope stays very vertical, it should anyway, straight up and down; and the body should stay facing forward, just moving the arm to the right and left to keep the loop going on either side of you. The rope should also be at the same height on both sides, not going up and down at all. I have really bad technique in all those areas, I'm afraid I learned bad habits young but I'm sure I can break it. The jump through I did was probably borne out of copying and approximating the actual Texas Skip, I learned the jump through from other chorus boys at a time when I hadn't ever seen the actual Texas Skip but I think someone saw it and figured a way to do something similar with a shorter rope and then passed it on to me.
So now looking at my jump through shortcomings with a critical eye: I tilt the rope so it's not quite vertical, it tends to be lower when on my right side, my head leans in and goes through the loop first, and I face my body more to the left side. Wow, I have a lot of work to do to clean this up, but at least I now have a rope more suited for the job.
Happy roping to you, and if you are also learning Texas Skip then let me know, we can trade tips and stories.