Ricoh 500GX - Re-furbishing the leather and the light seals
What the body normally looks like (thanks to Camera Wiki for supplying the below first image, I forgot to take a before shot):
This camera was the last in the 500 series lineup and manufacturing started in 1976. Common aging issues with this camera are the light seals leaking like mad, and the leather coming detached. These are the two problems we will address in this fix, let’s get started.
To get the front plate off you have to remove:
3 screws from the aperture ring (2MM Flat Head Required), and then remove aperture ring.
4 screws from the Shutter Ring and the 2 plastic screw holders (philips 2mm), and then remove shutter ring.
2 Pieces of leather from the metal body.
4 Screws from the metal body face.
Remove the front plate:
Give the front plate a good clean up on both sides before putting it back on to the camera.
Place back on to camera insert 4 face screws and tighten.
You are now ready to apply leather:
I drew out the diagram from the original leather on to the back of the new leather. I choose the wrong leather for the first two trials, and screwed up the third trial. The fourth take was a charm.
The first batch of leather was far too thick. This was purchased from a hobby store for $4. Failure 1.
After failure 1 I swapped from using Cement Glue to trying out Carpet Tape. Now this worked quite well for anything but curved surfaces (the edges of the camera) and the tape is useless if you touch it with your fingers (oils etc) so this was failure 2.
I was sick of buying leather from the hobby shop it just wasn’t the right stuff. I was about to give up. Then when at a salvage/thrift shop, I saw cheap pleather purses and handbags, and it came to me. CUT THEM SUCKERS UP.
Now I have plenty of faux leather to stuff up on.
This is how I organise the camera parts to keep sane. Little plastic sleeve protectors separate each category of parts.
The final drawings for the winning try.
Looking good, section 1 is a go.
Everything re-attached. Very pleased with the results. Jobs like this are definitely worth trialing on cheap cameras that don’t mean much to you. This camera cost me $15 at the same shop I bought the hand bag leather from to re-furb it.











