Tool case for the hammer drill I use at work. We were keeping it in its cardboard box, but that was starting to fall apart and wasn’t long enough to hold the drill bits that we use.
Dados in side panels and dry fitting with top and bottom panels before glue up.
The lid was then separated from the box by running all 4 sides on the table saw.
The dividers were made with interlocking plywood sections which were dado’d, glued, and brad nailed together, and then located into the box.
Cabinet hinges were installed on the lid with a kreg jig. The support piece was milled to a thickness that matched the depth of the lid so it fit perfectly.
Finished case lined with cardboard as padding for the tool and accessories! Questions, comments, and suggestions are always welcome!
