How to properly tie a tie
What is a good outfit without the perfect necktie? The tie remains an indispensable element in every male wardrobe, all at one time we had to make use of it, but you do it correctly?
The tie knot is the most difficult to want to use it. In addition, choosing the right one is essential if we want to look impeccable. If you ever had any problems in knotting it, here we solve all the easier. These are the loops you should know to do. Go practicing.
Place the tie around the neck leaving the right wider and longer than the narrow end.
1. Pass the wide end on the left below the narrow end.
2. Cross the widest point again right above the narrow and insert, from the bottom up, through the opening between the neck and the tie itself.
3. Stretch the wider end and put it in the overhand knot is created.
4. Hold the knot and stretch up slightly to fit the neck.
It is the most classic and most widely used because of its simplicity and versatility to match all kinds of shirts knot. The amplitude of this knot will depend on the width of the tie.
Place the tie around the neck leaving the right wider and longer than the narrow end.
1. Spend the wide part to the left over the narrow end.
2. Cross the widest point right again below the close.
3. Adelanta again the wide part above the narrow and insert, from the bottom up, through the opening between the neck and the tie itself.
4. Straighten the wider end and put it in the overhand knot is created.
5. Hold the knot and stretch up slightly to fit the neck.
Place the tie around the neck leaving the right wider and longer than the narrow end.
1. Spend the wide part to the left over the narrow end.
2. Cross the widest point right again below the close.
4. Adelanta again the wide end over the narrow and insert, from the bottom up, through the opening between the neck and the tie itself.
5. Stretch the wider end and put it in the overhand knot is created.
6. Hold the knot and stretch up slightly to fit the neck.
This knot has its own history. The monarchs of the mid-twentieth century were set up as the real trendsetters of the time, especially the Prince of Wales, who also holds the titles of Henry VIII and Duke of Windsor.
Indeed, the latter ccargo is what gives this knot. The loops that used the English king was very tight and bulky, but not because he used the Windsor knot later be called. In fact, the Duke realized an American knot his tie, whose volume was due to the commanding lining make this accessory. However, because of this mistake, a new way of knotting the tie with a result similar to the monarch, which was named Windsor was discovered.
The Windsor knot, more serious than the American, it is preferable to wear with Italian collar shirts or cutaway and thin ties.
Place the tie around the neck leaving the right wider and longer than the narrow end.
1. Spend the wide part to the left over the narrow end.
2. Enter the widest point through the gap between the collar and tie and pulled towards the right, leaving up the back of it.
3. Adelanta again the broad side to the left above the overhand knot.
4. Enter the widest point, from the bottom up, through the opening between the neck and the tie itself.
5. Stretch the wider end and put it in the overhand knot is created.
6. Hold the knot and stretch up slightly to fit the neck.
turnnoffyourmind
snowghoul
2087
baratheonpilled
jacobvanloon
theartofmadeline
