S13 update. fuse boxes are inside and wires are all run, when it was outside back in summer? tested the acc circuit to success, pop ups pop up, stereo works, all blinkers and lights. made seat rails for the red recaros. made my own bottom ount for the srd, and then modded some evo 4 bride rails for my s13 driver side, so low low and way way back work AND rails to move it back and forth. welded a hole in the floor and painted the inside for the harness blank outs. put the rear seats in for the first time in over 10yrs. grabbed the origin 50mm overs from the shelf, ive had these for around the same amount of time as the car, the flared arches were always meant to be temporary. these v1 overs fit...so so. ill see how they fit when i mod the rear end to accomidate an inner guard for tire issues so they dont destroy my glass. dropped the tank recently to swap to a non destroyed tank, cleaned the pump and got a new sock and put new fuel lines in the rear. BCWORKS did some welding projects for the stuff i am not good at (VERY thin steel) so i have a bunch of projects to get the front end assembled and be ready to fire soon for the first time in 3yrs...took on too many other projects and cars in the mean time, drifted the supra and cressida in the absence of the s13. once it runs again it will go outside for a little bit while i do some small projects and then back in it goes for the full rear end change of arms, overs, fit the big big equips. i want to get some mileage on the car this year but getting it out of the garage will be big enough of a step. it will get repainted the same two tone and BLACK STRIPE, all paint. i have a kit for it, fit the k’s wing better, kouki 180sx with lip front. idea is to do grip and drift with it. should be a fun grip car with grip tires lol
