Couple notes: This tutorial is just for the hood part of a jacket! The jacket I made using this tutorial by @furbmiester9000, which is adaptable for all furbys! Also, this tutorial is not for a plain hoodie. This if for a collared jacket that has a hood attached to it.Â
The only major change I made to the jacket was adding a spot for a tail, which ended up coming to about 2 inches tall and 1.5 inches wide, though youâll want to cut your hole smaller than that for seam allowance. I also curved the bottoms of the ends(blue arrows) so that it fit better over my furbys feet.
To get started on the hood, measure the length of your jacket, then put it on your furby and measure how high you want the hood to go from the fold of the collar. If you want to be able to take the hood off and have it sit comfortably around your furbys neck then make the height half of the length (e.g. my jacket came to about 12.5 inches so the height would be 6.25 inches). Otherwise itâll be kinda tight.
The hood is made up of two parts so halve your jacket length then draw out your hood shape on your fabric. I went with a square/rectangle shape with gave me a pointed looking hood. If you want a regular looking hood curve it. Look up different hood shapes and get creative!
Cut out two of those hood shapes, or four if you want your hood to have an inner lining. Remember to include seam allowance!
If you went with two pieces, sew the backside of the hood together.
If you went with four: Take two pieces, sew all but the backside together, then flip it inside out. Repeat with the other two pieces, then sew those two finished pieces together along the backside.
If you arenât making an inner lining for your hood, then you want to clean up the edges by either folding them in or using bias tape. You only have to do this for the 2 edges that are going to be visible around your furbyâs head and itâs up to you whether you want the fold on the outside or inside of the hood.
Next, mark the fold of the collar on your jacket. Then sew the bottom of the hood just below that line. Make sure youâre sewing the hood on the right way! The inside of the hood should be facing the same direction as the inside of the jacket.
Now you just have to sew the top of hood. Unless you went with a curved hood, in which case all you have to do now is make some ear holes!
For the ear holes, I just put the jacket on, found where the tips of the ears are, snipped a small hole, and then went from there. I recommend making very little cuts and checking after every cut that the fit is good. You donât want your holes too big or in the wrong spots.
As for finishing the hems on the ear holes⌠I actually didnât bother to finish mine lmao. If youâre worried about fraying or if you just want that professional finished look, you can fold them in and sew them up or you can use glue. Itâs up to you!
And thatâs it, your hood should be done! Hopefully this made enough sense and as always my ask box is open if you have any questions!
kianamaiart
stormborns
turnnoffyourmind
annaxmalina
romaincrisis
izzy806
