HIDCanada

Canada's High Intensity Discharge Lighting Specialists www.hidcanada.com

[hidcanada2009]

[hidcanada2009]

HID Error Canceller  Have you ever wondered what’s inside these “magical” cancellers people sell? How can shops sell “cancellers” without actually knowing or telling the end user what it is? We went out and purchased a pair of every singledifferent ones and tested them against the most common scenarios. This ensures that we can tell you exactly what’s inside and that it will work for you. If you would like to craft your own based on the components listed, feel free! Information empowers everyone, and what we found out was pretty intriguing. So What Did We Find? Some cancellers only had a small unmarked resistor All capacitors were 4700uF but varied widely in the vmax Many use plastic housings instead of heat dissipating metal NO ONE could tell us definitively what was inside their “canceller” NO ONE has actually done an investigation to this scale! If the canceller is very small, then it likely doesn’t contain what you need General Use Information: NOTE: Please contact us for specific use cases at our Support Portal Will not work with relay wiring harness or in bi-xenon applications For use to stabilize Daytime Running Light voltage, alleviating flickering Keep DRL at full voltage, allowing the HIDs to function normally Required for some one-off applications such as the 2006 BMW E92/E90 Eliminate bulb out warning for select problem vehicles (HIDC-C4) Error Canceller Contents: 2 x canceller units (one for each side) Full metal casing (very important for proper heat dissipation!) 2 x 5.1 ohm 20 watt resistor 1 x 16v 4700uF capacitor 3.0in x 2.5in x 1.5in size. This is LARGER than most!

[hidcanada2009]

Need a replacement bulb? No problem! Retrofit Type:Designed to replace bulbs from HID conversion kits. Typically [H1, H3, H4, H7, H8, H9, H10, H11, H13, 9004, 9005, 9006, 9007, 880, 881] size. Our bulbs use industry standard AMP/KET connectors and are compatible with most aftermarket ballast units. If there is ever any confusion or question, just give us a shout at http://help.hidcanada.com/ - - - Upgrade your factory HID lighting system with a fresh look! E4 and CE certified manufacture Philips UV-filtered quartz glass tube (Germany APL pill) Messer xenon gas charged with high purity mercury Sylvania OE electrode Luminous flux ~3200lm Lifetime ~3500 hours HID bulbs are sold in matched pairs only. Sorry, we do not offer any “off” tints beyond 8000K. Going any farther exponentially decreases the amount of usable light and attracts attention for the wrong reasons.

[hidcanada2009]

Need a replacement bulb? No problem! OEM Type: These are upgrade bulbs for vehicles with factory HID systems. Typically [D1S, D1C, D1R, D2S, D2C, D2R, D4S, D4C, D4R] size. Get OEM performance at less than half the price! If there is ever any confusion or question, just give us a shout at http://help.hidcanada.com/

[hidcanada2009]

HID Ballast What is it? Three months in the making, the HIDC-R4 kit is a revolutionary change from our previous HIDC-R3 mid-slim CANBUS system. We worked with our manufacturer to create a slimmer form factor without compromising performance or durability. Those that have been with us for some time may remember we condemned the “micro” sized ballasts for terrible reliability (among other things). Make no mistake that although this is a smaller ballast, it is not “micro” sized, it is small enough to fit inside even a Porsche Cayman headlight housing. What are those inline boxes for? You asked and we listened. You wanted a smaller form factor ballast for easier installation and mounting but wanted to retain the full digital CANBUS capability. In order to have your cake and eat it, the components are now housed inline in their own water resistant housings. The smaller box is the ignitor and is commonly seen on smaller ballasts.The bigger box is the CANBUS digital components and EMI filter. Why is one side silver and one side black? The bare metal side is for installation against the vehicle. Being bare, it allows for installation by strong adhesive (not included) rather than tapped screws. The other side is powder coated black with shallow grooves for heat sinking. This seemingly small detail plays a crucial role in longevity for this smaller ballast form factor. —- —- —- The HID Canada R-Series ballast is our flagship product and imbues the absolute latest technology to assert near 100% compatibility with all automotive applications. HID Canada R-Series ballast incorporates many new improvements including, but not limited to: Thinner form factor. Digitally regulated. EMI filtered. 35w full output (not just peak!) Extreme compatibility with the newest automotive systems

[hidcanada2009]

Sunwayman M11R (Premium Edition) Features:  ƒ_ CREE XML T6 4C Premium LED, with a lifetime of up to 50,000 hours ƒ_ Output and Runtime of three constant output modes (using CR123A) 180 Lumens (1.5hrs) - 60 Lumens (10hrs) - 4 Lumens (70hrs) Turbo Mode: 230 Lumens (using 16340 battery, do not run continuously at turbo > 10 min) Two Hidden Modes: Strobe, SOS * NOTE: Output lumens are based on XML U2 bin but should be similar to the T6 4C emitter ƒ_ Digital Sensor Magnetic Control system, slightly twist the rotator ring to select from different modes ƒ_ Constant current circuit, constant output ƒ_ Effective range of 130 meters ƒ_ Uses one single CR123A (RCR123A/16340) battery ƒ_ Working voltage: 0.9~4.2V ƒ_ High quality OP reflector maintains great throw distance and spread with an ideal beam pattern ƒ_ Dimensions: 75mm (length) x 23.2mm (head diameter) ƒ_ Weight: 45.5g‹¬_battery excluded‹¬_ ƒ_ Aerospace-grade aluminum alloy ƒ_ Military Specification Type III- hard anodized body ƒ_ Waterproof, in accordance with IPX-8 standard ƒ_ Ultra-clear tempered glass lens resists scratches and impacts ƒ_ Tail stand capable- can be used as a candle ƒ_ Accessories: Clip, Holster, O-ring, lanyard

[hidcanada2009]

Fenix BT10 Bike Light  BT10 is a professional bike light which employs Dual Distance Beam System. It features broad floodlight, close-in visibility and long-range illumination. BT10 employs the neutral white LED featuring the advantages of strong penetration power and good color rendering, which helps night riders better identify the color of objects and outdoor conditions, ensuring safety when mountain biking, touring, commuting, etc. Features · Utilizes Cree XP-G (R5) neutral white LED, max 350 lumens output · Powered by four AA batteries · Uses aspherical reflector, with a wide beam angle · Anti-glare lens design produces DUAL DISTANCE BEAM illumination · 3 brightness levels and one flashing mode · Quick to attach and detach using O-ring mounting straps sized for 20mm-35mmhandlebars · Able to adjust the direction of the headlamp freely · Made of aluminum alloy and performance plastic

[hidcanada2009]

Nitecore P12

Features

• Premium CREE XM-L2 (T6) LED

• Maximum output of 950 lumens

• Second generation ‘Crystal Coating Technology’ combined with ‘Precision Digital Optics Technology’ provide extreme reflector performance

• Boasts a peak beam intensity of 12,450cd and a throw distance of up to 222 meters

• High efficiency circuit board provides up to 520 hours runtime on low

• Side switch interface provides one-handed operation and easy access to all functions

• Side switch features an indicator light which displays remain ing battery power (patented)

• Power indicator ’s secondary function displays battery voltage (accurate to 0.1V)

• Intelligent memory function stores preferred brightness setting

• High-efficiency regulation circuit provides unwavering output

• Toughened ultra-clear mineral glass with anti-reflective coating

• Constructed from aero grade aluminium alloy with HAIII military grade hard-anodized finish

• Waterproof in accordance with IPX-8 (two meters submersible)

• Impact resistant to 1.5 meters

• Stainless steel titanium-plated clip included

• Tail stand capability

Dimensions

Length: 139mm (5.47”)

Head Diameter: 25.4mm (1”)

Tail Diameter: 25.4mm (1”)

Weight: 88grams (3.10oz)(without battery)

Accessories

Quality holster, clip, tactical ring, lanyard, spare tail cap, spare O-ring

Related

[hidcanada2009]

Fenix E05 is a portable high-intensity EDC flashlight. Featuring the negligible weight and volume, powerful water-resistance and the wear-resistant surface finish, E05 can be your ideal partner whenever and wherever. It performs well unconditionally with the characters of bright and soft flood light, sufficiently long runtime and simple but reliable operation mode. We believe E05 will be your best choices for EDC, collection and gifts.

[hidcanada2009]

With the Fenix TK75, four 18650 rechargeable cells are stunningly transformed into 2600 lumen max output. Throwing606mwith an 80-degree plus beam angle lets the TK75 light up extended terrain. On high at 1100 lumens, this compact Fenix flashlight pushes for four hours while the 400-lumen level stays the course at 12 hours runtime. The stainless crown, strobe and SOS functionality as well as the on-body dual switch system make the TK75 a trustworthy carry on search, caving and scouting missions. Mounted on a vehicle or stowed for emergency use, this light captures the proven performance found in every Fenix lighting product. Features - Uses Cree XM-L(U2) LED with a lifespan of 50000 hours - Uses four 18650 rechargeable Li-ion batteries - 185mm (Length) x 52.5mm (Diameter) x 87.5mm (Head) - 510-gram weight (excluding batteries) - Digitally regulated output - maintains constant brightness - Low-voltage warning function to alert users to replace the batteries - Reverse polarity protection guards against improper battery installation - Dual button switch system in the front for quick switching - Made of durable aircraft-grade aluminum - Premium Type III hard-anodized anti-abrasive finish - Toughened ultra-clear glass lens with anti-reflective coating

[hidcanada2009]

ARE-C2 is an advanced multi-charger compatible with broad spectrum of Li-ion and Ni-MH rechargeable cell sizes and capable of charging four different rechargeable batteries simultaneously while the LCD display keeps you informed with readouts of voltage and charging status. Utilizing our exclusive accelerated charging technology, it takes only three and a half hours to fully charge four ARB-L2 (2600mAh) 18650 rechargeable batteries. Features Broad spectrum of Li-ion and Ni-MH rechargeable cell sizes Automatically select charging modes based on the battery loaded Accelerated charging LCD display for battery voltage and charging status Four slots monitors and charges independently Advanced safety features Specifications Input: 100-240V (AC), 50/60Hz, 500mA (max) Input: 12V-24V (DC), 2000mA (max) Output: 4.2V / 1.5V 1000mAÇ_4 / 500mAÇ_4 Size: 156Ç_99.5Ç_37mm‹¬_LengthÇ_WidthÇ_Height‹¬_ Weight: 275g (excluding batteries) Operating Temperature: 5% (0ƒ_Ÿ) - 90% (40ƒ_Ÿ) (Full-load in normal working condition) Storage Conditions: Temperature: -20ƒ_Ÿ - 85ƒ_Ÿ

[hidcanada2009]

XTAR USB Output Analyzer - Coming Soon!!!

HID Canada is proud to announce we are receiving a very limited number of this awesome product from XTAR. There are a few USB "detectors" on the market but none from a reputable company such as XTAR and at such a competitive price. You've been invited the unique opportunity of ordering this fantastic bit of technology before anyone else has even heard of this device! The shipment date is anticipated for end of January. Please see the product image for details.

What are we using it for? One of our staff determined that his Samsung Galaxy Note 3 charges at different rates depending on what type of cable used. It varied between 0.3A to a whopping 1.5A! What will you use it for?

[hidcanada2009]

Nitecore 14500 Li-ion Rechargeable Battery 750mAh 3.7V 2.8Wh Integrated battery overcharge / discharge protection circuits High discharge performance Li-ion Rechargeable Battery · More than 500 charge-discharge cycles. · Internationally insured by Ping An Insurance(Group) Company of China, Ltd.

[hidcanada2009]

DarkMatter (18650) 3400mAh - VERSION 2 Now tougher and THINNER jacket than competing brands for better compatibility! HID Canada. Panasonic. These are the names behind this ultimate battery. Armed with a Japanese cell,Japanese protection IC, and copper negative contact plate, the DarkMatter 18650 3400mAh is unmatched. Let's get to the specs: * 18650 3400mAh Protected Rechargeable Battery * Normal Voltage: 3.6V * Panasonic NCR18650B Lithium Ion cell * Japanese IC Safety Circuitry * High Discharge Rate: 6.8A * Protection Circuitfor overcharge, over discharge, over current and short-circuit * 4.2 volts maximum with 3.6-3.7 volts nominal Why purchase batteries fromHID Canada? Each battery is subject to specific tests to ensure the highest quality. See here for more details:HID Canada Rechargeable Battery Preparation

[hidcanada2009]

HID Relay Wiring Harness Typically a wiring harness is not required unless the original wiring is low spec or quite aged. In those instances, a wiring harness (direct to battery) would be suitable.In other cases, a wiring harness is REQUIRED for installation. For example, a 2008 Mitsubishi Lancer would require a wiring harness to effectively bypass DRLs (if desired). Only ONE harness is required for each kit. This means one harness will feed two ballasts / bulbs. Give us a shout and we can help you decide whether a harness is suitable for your application! NOTE: Photograph is of a representative wiring harness. All high / low HID conversion kits such as H4, 9003, 9004, 9007, and H13 come with a wiring (controller) harness already included.

[hidcanada2009]

[hidcanada2009]

Shopping for someone else but not sure what to give them? Give them the gift of light with an HID Canada gift card. Gift cards start from $25 and can be used for more than one order until the value is depleted. Gift cards are delivered by email and contain instructions to redeem them at checkout. Our gift cards have no additional processing fees and do not expire. Finally, our gift cards are actually priced slightly lower as a token of our appreciation for a limited time! Happy shopping!