The really hilarious part is that the busted Yeti is even worse than this description makes it sound.
TL/DR version: the structural layout of the Expedition Everest attraction is so complicated that Disney had to use a technique called “previsualisaton” to construct it - essentially a four-dimensional blueprint that specifies not only how the structure should be put together, but the exact point in time that each step should occur. That precision in timing is actually kinda critical, because if certain parts of the structure are subject to stress too early (e.g., before the concrete is fully cured, before additional supports have been installed, etc.), they’ll be permanently weakened.
Well, long story short, when the ride went into action, Disney’s engineers quickly discovered that the numbers weren’t adding up: the internal stresses the ride was producing every time they turned the animatronic yeti on were literally tearing the whole mountain apart. It’s clear that something got screwed up during construction: either somebody performed a step with the wrong timing, or in the wrong order, or the previsualisaton was messed up to begin with. The trick is, they have no idea what the actual error was - and the ride can’t be repaired until they figure out what went wrong in the first place.
So now they just point a moving strobe light at the motionless yeti to create the illusion of motion, which is why it’s been nicknamed the “disco yeti”.
dededos
turnnoffyourmind
stormborns
blakekathryn
